Category: Electronic Locks

(Results from 61 to 70)
How do you order a rectifier kit (for AC power) for 6000 series electric strikes?
All 6000 series electric strikes are shipped with solenoids that require DC power.  Rectifier kits can be ordered to convert AC (from your power source) to DC.  Rectifier kit part numbers ar...
Schlage Commercial » Electronic Locks | Schlage Commercial » Power Supplies | Schlage Commercial » Von Duprin
Where is the MAC address on the LE lock?
You can find the MAC address on the sticker under the battery holder. The serial number is on the same sticker. ...
Schlage Commercial » Electronic Locks | Schlage Commercial » Electronic Locks » LE Series
What is the RLDB board used for?
This is a relay board the converts the high/low logic output to a simulated dry contact on a PIM or PIB .    RLBD Access point status signals: Request-to-enter Request-to...
Schlage Commercial » Electronic Locks
After LE Mortise lock was Re-Handed in the field, the REX function stopped working.
If the LE lock was re-handed on site, you have to make sure the stop screw is on the correct side.Check Install Guide (section A pg2) for moving Stop Screw and RX Module to the correct side of th...
Schlage Commercial » Electronic Locks | Schlage Commercial » Electronic Locks » LE Series
How can I downgrade firmware on an Engage device?
Only one Control version lock can be downgraded.Control devices that are programmed with Firmware 03.15.01 can be downgraded to any version.Here are the versions that you CANNOT downgrade from as of 0...
Schlage Commercial » Electronic Locks | Schlage Commercial » Electronic Locks » NDE Series | Schlage Commercial » Electronic Locks » Gateway | Schlage Commercial » Electronic Locks » LE Series | Schlage Commercial » Electronic Locks » CTE
AD latch 13-049 part number was changed to 13-247
Same component, different part number....
Schlage Commercial » Electronic Locks
How much amperage does the CTE require?
500 mA on 12/24 volts....
Schlage Commercial » Electronic Locks
What is the standard cylinder length for the LE wireless mortise lock?
The standard cylinder length that will ship with the lock is 1-1/2".  Other cylinder lengths will operate per the table below....
Schlage Commercial » Electronic Locks
Regarding the FE410F, is there a part number that can be ordered to convert lock ordered for 4” bore hole spacing to 5-1/2”?
There is nothing that can be ordered to convert them. If they were ordered as 4" and need to be 5.5", they would have to return the locks and reorder them. ...
Schlage Commercial » Electronic Locks | Schlage Commercial » Electronic Locks » LE Series
FE410.. when a card is presented... it gives a long beep.. then opens door..
Yes the Control lock firmware has a user indication if the real time clock tried to default back if power was lost in the lock for an extended period of time. To clear the long beep, please do a...
Schlage Commercial » Electronic Locks | Schlage Commercial » Multi-Family » FE410 | Schlage Commercial » Multi-Family » BE467

Support by product