Category: Electromagnetic Locks

(Results from 71 to 80)
Where on the door does the M490DE Signage get placed, is there Fire Marshall approved measurements?
This information would come only from the local Fire Marshall specific to each area. It will vary by juristiction....
Schlage Commercial » System Components » Electromagnetic Locks | Schlage Commercial » System Components » Electromagnetic Locks » M400 Series
What are the red and green wires on a Locknetics MG600 DT Magnetic Lock?
This is for the door position switch. It is an open circuit when door is open, and a closed circuit when the door is closed....
Schlage Commercial » System Components » Electromagnetic Locks
Can you convert an M490 to an M490P?
Not fully or officially. But you could swap out the armature for one with magnets and install the PCB assembly from the M490P. This would allow you to DSM but not MBS....
Schlage Commercial » System Components » Electromagnetic Locks | Schlage Commercial » System Components » Electromagnetic Locks » M400 Series
Can the M490G be used with a delayed egress controller for an outside installation?
Yes, the M490G can be used with a delayed egress controller. Make sure you have all the additional necessary items such as a delayed egress trigger and       visual and audible indicati...
Schlage Commercial » System Components » Electromagnetic Locks | Schlage Commercial » System Components » Electromagnetic Locks » M400 Series
Can I paint my maglock because they only come in one color?
We do not recommend and advise against painting or altering the mag lock housings in any way. This will void warranty of the lock and could cause unforeseen circumstances/issues....
Schlage Commercial » System Components » Electromagnetic Locks | Schlage Commercial » System Components » Electromagnetic Locks » M400 Series | Schlage Commercial » Locknetics
What ANSI A156.23 Grade is the GF3000?
    The GF3000 is ANSI A156.23 E18602 Grade 2....
Schlage Commercial » System Components » Electromagnetic Locks | Schlage Commercial » System Components » Electromagnetic Locks » GF3000 Series
Does alarm out on a M490DEP work as the alarm instead of the piezo alarm, or does it work with the piezo alarm, and do all the same alarms signal?
The Alarm out well work with and goes off with everything the piezo alarm does, except the nuisance alert....
Schlage Commercial » System Components » Electromagnetic Locks | Schlage Commercial » System Components » Electromagnetic Locks » M400 Series
Can you disable the ARSM on the GF3000?
No, it is built in. There is no way to disable it....
Schlage Commercial » System Components » Electromagnetic Locks | Schlage Commercial » System Components » Electromagnetic Locks » GF3000 Series
Why do you need a full 2-3/4 inch header to mount our M400 mag lock series?
We usually state that the complete width of maglock housing and armature with holder is 2 3/4". The lock width is 1 3/4" and the armature with holder add another 1".That is why we call out 2 3/4" for ...
Schlage Commercial » System Components » Electromagnetic Locks | Schlage Commercial » System Components » Electromagnetic Locks » M400 Series
What is measurement/thickness of the MUBK bracket across the top?
0.124 inch or 3mm, (1/8), we would recommend 3/16" or more clearance for install....
Schlage Commercial » System Components » Electromagnetic Locks | Schlage Commercial » Locknetics

Support by product