Category: Electromagnetic Locks

(Results from 1 to 10)
M400-Series Electromagnetic Lock - Cover Screw Size
US 8-32 X 1/4 Inch length Phillips head. The same size can be used for a Torx/Security screw. ...
System Components » Electromagnetic Locks
Schlage M490DE Maglock - Can Delay Egress be Remotely Disabled
No, only via DIP switch 8 and/or the aux input. ...
System Components » Electromagnetic Locks
Schlage M420, M450, M490 - Armature Bolt Replacement
The armature bolt is not available on its own, but it is included in the armature mounting fastener pack, part# P44489128 for M450/M420 P44497110 for M490 ...
System Components » Electromagnetic Locks
Installing Electromagnetic Locks on Surface Vertical Rod Doors
It can be installed frame side of the rods, if there is room for it on the door. Note: The holding force will be reduced when the maglock is not installed as close to the edge of the door as pos...
System Components » Electromagnetic Locks
On the M450P, does this indicator light come with the lock?
No, it is in a kit sold separately (ATS/LED kit) and the lock must be a Plus "P" version to use this kit.  This can be ordered separate and installed in the field....
System Components » Electromagnetic Locks | System Components » Electromagnetic Locks » M400 Series | System Components » Electromagnetic Locks » M400 Series » Schlage Electronics
Schlage M400-Series - HDB Kit Screw Sizes
(3) 10-32 x 3/8 set screws included with HDB brackets.  Applies to HDB420, HDB450, and HDB490 ...
System Components » Electromagnetic Locks
Is there a maintenance recommendation for Schlage Electromagnetic Locks?
At twelve (12) monthly intervals the following maintenance should be followed; All fixing screws checked and tightened on the mag lock & armature plate. External surfaces wiped over...
System Components » Electromagnetic Locks
How do you use an auto operator with M490DE?
Yes, you can, but you will need a secondary relay that will trigger the release input prior to triggering the auto operator to open.  When using the Schlage PS900 series power supplies, you...
System Components » Electromagnetic Locks
Does the GF3000SM use the same armature as the GF3000?
Yes, you will need the TRD armature. The bolts for the armature assembly are shorter for the TRD and that is what is needed for the Gf3000SM ...
System Components » Electromagnetic Locks | System Components » Electromagnetic Locks » GF3000 Series
Using the M490DEP, does the door prop time reset with each card swipe?
Yes, the 20 second timer will restart, once the release contacts are reopened....
System Components » Electromagnetic Locks | System Components » Electromagnetic Locks » M400 Series | System Components » Electromagnetic Locks » M400 Series » Schlage Electronics

Support by product