Category: Readers

(Results from 11 to 20)
What are the measurements of the WPR400 with a card reader?
H 6-1/4 inches Width, without handle: 3-1/2 inches           With handle: 4-7/8 D at deepest point: 3-3/8...
Schlage Commercial » Readers
What colors are available for Schlage card readers?
Black (standard), Cream, Cool Tone Gray, and Warm Tone Brown....
Schlage Commercial » Readers
On a MTK15 reader, if they want to use a single wire for LED control, which would they use? Brown or Orange?
Orange to control the Green LED. The red light is normally on solid unless the orange wire is triggered....
Schlage Commercial » Readers
How do you specify RS485 option when ordering Schlage MT15 readers?
MT15-485...
Schlage Commercial » Readers
Is there a configuration card that disables report CSN for the Schlage readers?
The reader does either secure sector or CSN, but not both unless it is iClass CSN. By default the CSN is disabled so that it can read the secure sector of our cards....
Schlage Commercial » Readers
On the MT15-485, what does the A/Y and B/Z signify for RS485-B/Z, RS485-A/Y?
Pink is A/Y and Tan is B/Z which is only on readers that have been ordered with 485 configuration. MT15-485 is printed on every reader's sticker. A/Y is negative or inverting pin, B/Z is the positive...
Schlage Commercial » Readers
What is the gray wire for on MT readers?
The Tamper out is the gray wire.  It is an open collector that holds at 5V then sinks to ground...
Schlage Commercial » Readers
What is the Wiegand pulse width for the MT15 reader?
100 microseconds....
Schlage Commercial » Readers
Can the MT20 reader can be used to enroll PIV credentials with Express and AD201 locks?
Yes, it should work, the MT20 will output the same data as the AD reader should be reading (when in 75-bit mode)...
Schlage Commercial » Readers
What is the warranty on the magstripe part of the reader on a MTMS-15 reader?
One year on the mag stripe reader head....
Schlage Commercial » Readers

Support by product