Category: Multi-Technology

(Results from 1 to 10)
What baud rate can an Schlage RS485 communicate?
By default, the baud rate is set for 9600.  The reader can however be programmed via OSDP commands to communicate at: 14400, 19200, 28800, 38400, 57600, 115200, and 230400. ...
Schlage Commercial » Readers » Multi-Technology
The MTMS15 or MTMSK15 reader does not read a magstripe card
The three most common reasons for these are as follows: 1.  During installation, the wiring for the magstripe reader may not have been connected to the main reader.  Please remove the main ...
Schlage Commercial » Credentials » Magnetic Stripe » MAG Series » Schlage Electronics | Schlage Commercial » Readers | Schlage Commercial » Readers » Magnetic Stripe Readers | Schlage Commercial » Readers » Multi-Technology | Schlage Commercial » Readers » Multi-Technology » MTSeries
Can I use the SUSB89/SSRL89 enrollment readers to read the CSN from an iClass card?
On the current enrollment readers (SUSB89/SSRL89), they do not read the CSN of any smart card including iclass....
Schlage Commercial » Electronic Locks » Offline | Schlage Commercial » Electronic Locks » Offline » AD 200 Series | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics | Schlage Commercial » Readers » Multi-Technology | Schlage Commercial » Readers » Multi-Technology » MTSeries | Schlage Commercial » Readers » Multi-Technology » MTSeries » Schlage Electronics | Schlage Commercial » Readers » Smart Card | Schlage Commercial » Readers » Smart Card » Enrollment | Schlage Commercial » Software | Schlage Commercial » Software » Schlage Express | Schlage Commercial » Software » Schlage Express » Peripherals | Schlage Commercial » Schlage Electronics
Will the MiK readers read prox?
It's essentially the same as the usual MT reader except that it has an embedded HID iclass reader to read the secure part of an iclass card. So yes it will....
Schlage Commercial » Readers | Schlage Commercial » Readers » Multi-Technology
How do you disable the LEDs and Beeper on Schlage readers?
Use configuration card CE-ALL-OFF...
Schlage Commercial » Readers | Schlage Commercial » Readers » Multi-Technology | Schlage Commercial » Readers » Proximity | Schlage Commercial » Readers » Smart Card
What type of circuit is on the Schlage MTMSK Crad Reader Tamper switch?
The MTMSK tamper is an Open Collector.  The tamper leads will show approx 5v when closed and then drops to ground when open....
Schlage Commercial » Readers » Multi-Technology
Does the Keypad on an Schlage MT reader illuminate?
When any key is pressed the Keypad will back light....
Schlage Commercial » Readers » Multi-Technology
On the MTK15 are you able to keep the keypad lit all the time?
Yes, The CE-000-046 configuration card works (keypad backlight ON.) The light remains on even on idle and blinks for every key press and card read....
Schlage Commercial » Readers » Multi-Technology
Are Schlage multi-technology readers capable of supporting multi-drop, Open Standard Device Protocol (OSDP) functions?
By default our MTxx-485 readers are configured for Secure OSDP.The Schlage multi-technology readers must be configured as RS-485 in order to support Open Standard Device Protocol (OSDP). RS-485 m...
Schlage Commercial » Readers » Multi-Technology
Will the MT15 series work with a OSDP?
Yes, the reader needs to ordered as a RS-485, make sure it is not a Wiegand reader....
Schlage Commercial » Readers » Multi-Technology | Schlage Commercial » Readers » Multi-Technology » MTSeries