The MTMS15 or MTMSK15 reader does not read a magstripe card
The three most common reasons for these are as follows:
1. During installation, the wiring for the magstripe reader may not have been connected to the main reader. Please remove the main ...
Schlage Commercial » Credentials » Magnetic Stripe » MAG Series » Schlage Electronics | Schlage Commercial » Readers | Schlage Commercial » Readers » Magnetic Stripe Readers | Schlage Commercial » Readers » Multi-Technology | Schlage Commercial » Readers » Multi-Technology » MTSeries
How do I change the track on an MTMS15 magstripe reader?
Power cycle the reader, wait for the beep then present configuration card to the reader within 60 seconds (see chart below for config cards).
...
Schlage Commercial » Credentials » Magnetic Stripe | Schlage Commercial » Readers » Magnetic Stripe Readers | Schlage Commercial » Readers » Multi-Technology | Schlage Commercial » Readers » Multi-Technology » MTSeries | Schlage Commercial » Readers » Multi-Technology » MTSeries » Schlage Electronics
Why is my MR2 reader not working the same way as my new MTMS readers?
The MTMS outputs magstripe data in Wiegand protocol rather than in Clock/Data....you need to use a CE-401-062 config card to change the Magstripe output to Clock/Data, then Enable CT5000 Clock and D...
Schlage Commercial » Credentials » Multi-Technology | Schlage Commercial » Readers » Magnetic Stripe Readers
Video: Enrolling a credential using the CRP2
Video: Enrolling a credential using the CRP2Schlage Express - Enrolling Credential by Presentation using CRP2 - YouTube ...
Schlage Commercial » Credentials » Magnetic Stripe | Schlage Commercial » Readers | Schlage Commercial » Readers » Magnetic Stripe Readers | Schlage Commercial