Where is the pivot point located on a 041XY hinge?
The pivot point is located approximately 1/2" off the face of the frame and approximately 2" from the edge of the door....
Schlage Commercial » Mechanical Accessories » Hinges & Pivots | Schlage Commercial » Mechanical Accessories » Hinges & Pivots » Ives | Schlage Commercial » Ives
Where is EPT location for 700 series hinge?
Refer to both pricebook and templates for EPT diagrams and locations.
Standard lengths and EPT locations are shown below.
If a non-standard size is needed, the next-larger size will be...
Schlage Commercial » Mechanical Accessories » Hinges & Pivots
What is the diameter of a 5BB1 hinge pin?
Diameter is 5/16" with a wider knurled collar under the pin, though the hinge pin is not always consistently that size and may vary slightly.
This is commonly asked to see if this hinge wi...
Schlage Commercial » Mechanical Accessories » Hinges & Pivots
Can a Bar Coordinator be used with Offset Pivots?
There is a small chance that this combination could work, but it often does not work properly.
Because of the location of the pivot point, the active door lever of a Bar Coordinator (COR32, COR4...
Schlage Commercial » Mechanical Accessories » Flush Bolts and Coordinators | Schlage Commercial » Mechanical Accessories » Flush Bolts and Coordinators » Ives | Schlage Commercial » Mechanical Accessories » Hinges & Pivots | Schlage Commercial » Mechanical Accessories » Hinges & Pivots » Ives
Is the 705 pin and barrel continuous hinge furnished with Adjusta-studs?
Yes, this is the only hinge that ships standard with Adjusta-studs and corresponding machine screws. It also ships with self-drilling self-tapping screws if Adjusta-stud method of installation i...
Schlage Commercial » Mechanical Accessories » Hinges & Pivots | Schlage Commercial » Mechanical Accessories » Hinges & Pivots » Ives | Schlage Commercial » Ives
What Ives hinge is labeled 27G5?
27G5 is not a model number.
It is the UL listing stamped into Ives Aluminum Geared Continuous Hinges.
To identify the model of the hinge, compare the shape and size of the door and fram...
Schlage Commercial » Mechanical Accessories | Schlage Commercial » Mechanical Accessories » Hinges & Pivots
Where is the EPT prep on an Ives continuous hinge if I order a custom length?
The EPT location on continuous hinges is always measured from the top of the continuous hinge to the CenterLine of the EPT location.
For that reason, the bottom of the hinge is cut to make custo...
Schlage Commercial » Mechanical Accessories » Hinges & Pivots | Schlage Commercial » Mechanical Accessories » Hinges & Pivots » Ives | Schlage Commercial » Ives
Does Ives offer a continuous hinge or pivot for lead lined doors?
Ives does not offer a continuous hinge designed specifically for lead lined doors. Standard hinges may work if the hinge and mounting hardware do not penetrate the lead lining in the door. ...
Schlage Commercial » Mechanical Accessories » Hinges & Pivots | Schlage Commercial » Mechanical Accessories » Hinges & Pivots » Ives | Schlage Commercial » Ives
Does a 7230 SET come with intermediate pivots?
A pivot SET is defined in the catalog as being a TOP pivot and a BOTtom pivot.The number of INTermediate pivots used in a given application vary depending on the door height and weight, so they are no...
Schlage Commercial » Mechanical Accessories » Hinges & Pivots