Category: Hinges & Pivots

(Results from 1 to 10)
Where is EPT location for 700 series hinge?
Refer to both pricebook and templates for EPT diagrams and locations. Standard lengths and EPT locations are shown below. If a non-standard size is needed,  the next-larger size will be...
Mechanical Accessories » Hinges & Pivots
What is the diameter of a 5BB1 hinge pin?
Diameter is 5/16" with a wider knurled collar under the pin, though the hinge pin is not always consistently that size and may vary slightly.  This is commonly asked to see if this hinge wi...
Mechanical Accessories » Hinges & Pivots
Can a Bar Coordinator be used with Offset Pivots?
There is a small chance that this combination could work, but it often does not work properly. Because of the location of the pivot point, the active door lever of a Bar Coordinator (COR32, COR4...
Mechanical Accessories » Flush Bolts and Coordinators | Mechanical Accessories » Flush Bolts and Coordinators » Ives | Mechanical Accessories » Hinges & Pivots | Mechanical Accessories » Hinges & Pivots » Ives
Has Ives ever made, or have as a special, a "reverse acting" hinge?
Allegion / Ives does not offer a reverse acting hinge.  ...
Mechanical Accessories » Hinges & Pivots
Does Ives offer a continuous hinge or pivot for lead lined doors?
Ives does not offer a continuous hinge designed specifically for lead lined doors.  Standard hinges may work if the hinge and mounting hardware do not penetrate the lead lining in the door. ...
Mechanical Accessories » Hinges & Pivots | Mechanical Accessories » Hinges & Pivots » Ives | Ives
Where is common cutout for Von Duprin EPT prep in Ives 224 Continuous Hinge?
Cutout depends on the size of 224 hinge.  See 112HD/224HD-EPT template.  112HD/224HD continuous hinge  Center line of EPT to top of the door  83 inches  30 inches  85 inches  32...
Mechanical Accessories » Hinges & Pivots » Ives | System Components » Power Supplies » EPT Series » Von Duprin
Do you sell lead lined pivots?
Ives does not offer any lead lined pivots.  An appropriate model of pivot would be determined by the weight of the door and where the lead lining is in the door.  Because Lea...
Mechanical Accessories » Hinges & Pivots » Ives
Which electrified hinge is required or recommended for use with EL devices?
Recommend at least a 4 wire hinge and double up the wires for EL application....
Mechanical Accessories » Hinges & Pivots » Ives
Do we have a maximum door width or height for using pivots?
The maximum door width that pivots have been tested is a 4' wide door.  Any door greater than 4' would shorten the life of the pivots. There is no maximum door height, for offset pivots the rule...
Mechanical Accessories » Hinges & Pivots » Ives
What is the template for 5BB1HW for Swing Clear Hinges?
See attached templates.  5BB1HW Swing Clear Hinges...
Mechanical Accessories » Hinges & Pivots » Ives