Category: Von Duprin

(Results from 21 to 30)
If you order the Von Duprin trim only do you get the screw pack for a 1 3/4" and 2 1/4" door?
All Von Duprin 98 and 99 trims include screws for both 1 3/4" and 2 1/4" thick doors....
Schlage Commercial » Von Duprin
How do I replace an E996L solenoid?
Order E-Trim Mech Kit  part #050671-00 which will include a new solenoid already mounted to the blocking mechanism. See installation instruction # 921297 here which will show how to remove blocki...
Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin | Schlage Commercial » Von Duprin
Can we get knurling on 990 pull trims?
Knurling not available on any pulls....
Schlage Commercial » Von Duprin
What are the part numbers for the 34 or 58 mortise lock bodies?
The only parts that are available for 34/58 for mortise lock bodies are: 091032 Aux Bolt Spring Pack of 10 091031 Dog Spring Pack of 10 091030 Thumb Spring Pack of 5...
Schlage Commercial » Von Duprin
What parts are required with NLon the 5547 with pull by others?
The 555NL cylinder assembly must be ordered....
Schlage Commercial » Exit Devices » Cross Bar » 55 Series » Von Duprin | Schlage Commercial » Von Duprin
What is the difference between the 376T and the 360T trim when it is used with Von Duprin 33/3547A exit device?
The 376T trim activates and connects to the 33/3547A top rod. The 360T activate and mounts to the 33/3547A center case....
Schlage Commercial » Exit Devices » Touch Bar » 33A/35A Series » Von Duprin | Schlage Commercial » Von Duprin
What is the minimum clear opening width required by ADA on a single door?
The minimum clear opening width for ADA is 32" measured from face of door opened to 90 degrees to face of stop on strike jamb. There must be no hardware mounted to the door projecting i...
Schlage Commercial » LCN | Schlage Commercial » Schlage | Schlage Commercial » Steelcraft | Schlage Commercial » Von Duprin
What is a 266M?
266M is on all Von Duprin exit devices and does not identify the device....
Schlage Commercial » Von Duprin
What type of cylinder does theVon Duprin 373L trim take?
All Von Duprin 370 Series trims require a 1 1/4" mortise cylinder with a straight cam....
Schlage Commercial » Von Duprin
Should a solenoid be hot to the touch?
If there is concern that the solenoid or device is "too hot" or has the capability to cause injury, disconnect the device and contact a authorized service representative to analyze the opening....
Schlage Commercial » System Components » Electric Strikes » 6000 Series » Von Duprin | Schlage Commercial » Von Duprin

Support by product