Category: Senior Swing

(Results from 81 to 88)
Can the LCN 2800 concealed senior swing operator be used with pocket pivots or swing clear hinges?
The 2800 series operator cannot be used with pocket pivots nor swing clear hinges.These hinges have too much rotation and arm does not have enough travel in the door....
Schlage Commercial » Automatic Operators | Schlage Commercial » Automatic Operators » Electromechanical » Senior Swing
Is the LCN Sr Swing operator UL listed for use on fire doors?
The LCN Sr Swing operator is UL listed for use on Fire doors.  Also, evaluated in accordance with the standard, UL10C.0C....
Schlage Commercial » Automatic Operators | Schlage Commercial » Automatic Operators » Electromechanical » Senior Swing
Are the senior swing angle brackets handed?
The senior swing angle brackets (334-1) are handed.  When you order the 9540-334-1 angle brackets, you will receive one A and one B bracket with the surface mounted senior swing...
Schlage Commercial » Automatic Operators | Schlage Commercial » Automatic Operators » Electromechanical » Senior Swing
What is the thread size of the threaded rod on the senior swing push arm?
The thread size of the rod on the push arm for the senior swing is 3/8-24. ...
Schlage Commercial » Automatic Operators | Schlage Commercial » Automatic Operators » Electromechanical » Senior Swing
Is there a recommended distance between a senior swing and a remotely mounted control box?
This distance should be within a distance where our standard wire connections (plugs) can reach without being modified....
Schlage Commercial » Automatic Operators | Schlage Commercial » Automatic Operators » Electromechanical » Senior Swing
Can the sr swing header be cut down in the field?
We would not recommend doing this but if it is a single door header you can physically cut it down. Just make sure the end that is cut is the control box end not the motor end and minimum it should be...
Schlage Commercial » Automatic Operators | Schlage Commercial » Automatic Operators » Electromechanical » Senior Swing
Can the Sr Swing concealed operator work with concealed vertical rods?
You can use concealed vertical rods with the 2800 series concealed operator with special templates and must use OP arms, no center pivots. If using a double door 2810DD/MP, 2850 or 2860 you would orde...
Schlage Commercial » Automatic Operators | Schlage Commercial » Automatic Operators » Electromechanical » Senior Swing
What is the length of the 2810-168 Slide?
The 2810-168 slide length is 11”. For OP arm template, see here....
Schlage Commercial » Automatic Operators | Schlage Commercial » Automatic Operators » Electromechanical » Senior Swing

Support by product