Category: RC-04

(Results from 21 to 25)
Can Pure Access accommodate read in-read out entrances?
Yes, for 12V low current fail secure devices, two reader controllers (RC-04, RC11, RC15) or one 2 door bridge can be used. For higher current, voltage, or fail safe devices, a minimum of one ASM will ...
Schlage Commercial » Software » Isonas » Pure Access Cloud | Schlage Commercial » Software » Isonas » RC-04 | Schlage Commercial » Software » Isonas » IPBridge | Schlage Commercial » Software » Isonas » RC Reader Controller
Zentra - What Devices Are Supported?
The Schlage/Isonas devices supported by Zentra Living (as of March 2024):Schlage Control (BE467 and FE410)Schlage RC Reader Controller (RC11, RC15, RCK15)Devices Coming to Zentra Living:Schlage NDE-se...
Schlage Commercial » Electronic Locks » NDE Series | Schlage Commercial » Electronic Locks » LE Series | Schlage Commercial » Electronic Locks » CTE | Schlage Commercial » Multi-Family » FE410 | Schlage Commercial » Multi-Family » BE467 | Schlage Commercial » Software » Isonas » RC-04 | Schlage Commercial » Software » Isonas » IPBridge | Schlage Commercial » Software » Isonas » RC Reader Controller | Schlage Commercial » Software » Zentra
What is the difference between the RC-04-PRX-M and the R-1-MCT-M?
Both the MCT and the PRX models will read 125KHz proximity credentials, but the MCT also reads the13.56MHz smart cards. The MCT model will not read the secure sector data on non-Isonas smart cred...
Schlage Commercial » Software » Isonas » Pure Access Cloud | Schlage Commercial » Software » Isonas » RC-04
Should the RC04 LED turn amber/yellow after an Isonas Pure Mobile credential has been presented?
Yes, after presenting the Isonas Pure Mobile credential to the reader, the RC04’s LED will illuminate amber/yellow before turning either green for approval or red for decline....
Schlage Commercial » Software » Isonas | Schlage Commercial » Software » Isonas » Pure Access Cloud | Schlage Commercial » Software » Isonas » RC-04
What does ‘Device Disconnect’ and ‘Device Connect’ events mean in Pure Access Cloud?
‘Device Disconnect’ and ‘Device Connect’ events are normal in Pure Access Cloud as long as the disconnect lasts approximately 15-30 seconds. These can be caused by Pure Access Cloud updates or...
Schlage Commercial » Software » Isonas » Pure Access Cloud | Schlage Commercial » Software » Isonas » RC-04 | Schlage Commercial » Software » Isonas » RC-03 | Schlage Commercial » Software » Isonas » IPBridge | Schlage Commercial » Software » Isonas » RC Reader Controller