Category: CTE

(Results from 51 to 60)
Will CTE controller support MTK-15 readers?
No, currently keypads are not supported on any Engage platform device....
Schlage Commercial » Electronic Locks » ENGAGE Application | Schlage Commercial » Electronic Locks » CTE
How do you Factory Default a CTE?
Press and Hold the FDR button for at least 5 seconds. Release the FDR button. Press the SCHLAGE button 3 times. You should hear a single beep and see a green LED. Verify the MODE ind...
Schlage Commercial » Electronic Locks | Schlage Commercial » Electronic Locks » CTE
What is the relock time delay for the CTE?
 What is the relock time delay for the CTE? The CTE relock delay can be adjusted to as low as 1 sec. and as high as 30 sec. ...
Schlage Commercial » Electronic Locks | Schlage Commercial » Electronic Locks » CTE
On the CTE what causes the fault LED to be on?
If the CTE 12V power to the reader is shorted, the CTE fault LED by the reader                          connector will be on. Cl...
Schlage Commercial » Electronic Locks » CTE
I created a Holiday schedule on the Engage portal but it didn't list any Assigned Devices.
After creating the holiday schedule on the web portal, you must assign the holiday to the devices and then go to each door and SYNC to update the device.  Or wait overnight if you locks ar...
Schlage Commercial » Electronic Locks » ENGAGE Application | Schlage Commercial » Electronic Locks » NDE Series | Schlage Commercial » Electronic Locks » LE Series | Schlage Commercial » Electronic Locks » CTE
Will NDE80/NDEB80 locks read Indala cards?
No, none of our Engage series locks can read the the Indala cards. Only Indala readers can read the Indala cards. ...
Schlage Commercial » Electronic Locks » NDE Series | Schlage Commercial » Electronic Locks » LE Series | Schlage Commercial » Electronic Locks » CTE
Does updating CTE firmware also update the connected reader firmware?
When you do a firmware upgrade on the Engage CTE controller, you will also update the firmware on the MTB readers....
Schlage Commercial » Electronic Locks » CTE
Can you install a DPS on CTE?
Yes, you can wire a DPS into the CTE controller.Under Inputs,  you will see the option for DPS.  You can wire it to those connections....
Schlage Commercial » Electronic Locks » CTE
How do you cancel construction mode on CTE?
To cancel the Construction Mode and to remove all credentials, perform a factory default reset. When Construction Mode is cancelled, the Master Construction Credential and all other added UserCon...
Schlage Commercial » Electronic Locks » CTE
Which model readers will work with the CTE?
With the CTE controller, you can only use 485 readers.You can use the MTB11, MTB15, MT11-485 and the MT15-485.You cannot use the MT11 or the MT15 readers...
Schlage Commercial » Electronic Locks » CTE