Are the CTE outputs fault protected?
The CTE outputs are overcurrent fault protected.
The outputs share a RED FAULT LED, when ON the RED LED indicates there is an overcurrent fault on one of the outputs. When the fault removed the ...
Schlage Commercial » Electronic Locks » CTE
What are the wiring requirements for the CTE?
For the MTB readers, 22 ga is suggested from pigtail to the CTE's RS485 terminal connection.
For all other devices wired to CTE, including direct line power, use 18ga wire for typical installati...
Schlage Commercial » Electronic Locks » CTE
How can I upgrade Firmware on my MTB reader?
The MTB readers will only show in a Partner Site in Engage to be able to update the firmware.
In a Engage Managed site, connect the MTB to a CTE.
When you update the firmware on the CTE, it ...
Schlage Commercial » Electronic Locks » CTE
Why can't a Wiegand Card reader be used with CTE?
There are terminals for Wiegand connection. Those terminals were part of original board design and may be implemented in the future, but for now CTE only supports RS485 communications.
...
Schlage Commercial » Electronic Locks » CTE
Do you have How To or training videos for the Engage locks?
Please click here for the web page with the link for the training videos.Once you go to the page, please click on Schlage Electronics for the Engage locks selection.We also have a YouTube page with mo...
Schlage Commercial » Electronic Locks » ENGAGE Application | Schlage Commercial » Electronic Locks » NDE Series | Schlage Commercial » Electronic Locks » LE Series | Schlage Commercial » Electronic Locks » CTE
In Engage, how to lock down a door that is on an unlock schedule?
If the door is on an unlock schedule and you need to lock it down, you can present a toggle card to the door. That will lock the door and the next day the door will unlock on the sch...
Schlage Commercial » Electronic Locks » ENGAGE Application | Schlage Commercial » Electronic Locks » NDE Series | Schlage Commercial » Electronic Locks » LE Series | Schlage Commercial » Electronic Locks » CTE
Can a CTE be used on an elevator?
Yes, the CTE can grant access to the elevator, but it cannot access individual floors....
Schlage Commercial » Electronic Locks » CTE
Why is my engage lock not linking to the Gateway?
Please make sure the Engage lock you are trying to link is commissioned to the same site as the Gateway.
Once commissioned then follow the steps to link the lock to the Gateway.
...
Schlage Commercial » Electronic Locks » ENGAGE Application | Schlage Commercial » Electronic Locks » NDE Series | Schlage Commercial » Electronic Locks » Gateway | Schlage Commercial » Electronic Locks » LE Series | Schlage Commercial » Electronic Locks » CTE