Can the BE467 be programmed using Schlage Express?
The BE467 deadbolt and FE410 interconnected lock are not compatible with Schlage Express or the iButton-based Schlage Vendor Access Management system....
Schlage Commercial » Electronic Locks » Offline » Multi-Family | Schlage Commercial » Electronic Locks » Offline » Multi-Family » Schlage Electronics | Schlage Commercial » Software » Schlage Express | Schlage Commercial » Software » VAM | Schlage Commercial » Schlage Electronics
Can access schedules be assigned to BE467 users?
In Advanced Mode (using a third-party EAC system), access schedules may be possible, depending on the capabilities of the EAC system....
Schlage Commercial » Electronic Locks » Offline » Multi-Family | Schlage Commercial » Electronic Locks » Offline » Multi-Family » Schlage Electronics | Schlage Commercial » Schlage Electronics | Schlage Commercial » Electronic Locks » ENGAGE Application | Schlage Commercial » Electronic Locks » ENGAGE Application » Web App
How do you unlock a Schlage Control lock that has a dead battery?
Battery Jump Procedure: The emergency battery jump start can be used to unlock the door if the batteries are dead. WARNING: The lock will remain unlocked until you change the battery and reloc...
Schlage Commercial » Schlage Electronics | Schlage Commercial » Multi-Family » FE410 | Schlage Commercial » Multi-Family » BE467
How do you factory default reset a Schlage Control lock?
1. Disconnect the batteries for at least ten (10) seconds.
2. Reconnect the batteries.
3. Wait for the lock to beep and flash three (3) times.
4. Within ten (10) seconds, rotate the inte...
Schlage Commercial » Electronic Locks » Offline » Multi-Family | Schlage Commercial » Schlage Electronics | Schlage Commercial » Electronic Locks » ENGAGE Application
What card readers work with the CTE?
Because of the secure features, CTE only operates with a Schlage MT11-485 or MT15-485 wall reader.The CTE is only sold as a KIT which includes the choice of MT11-485, narrow mullion, or MT15-485, squa...
Schlage Commercial » Readers » Multi-Technology | Schlage Commercial » Schlage Electronics | Schlage Commercial » Electronic Locks » CTE
CTE reader TEST
The reader must be connected to the RS-485, NOT to the weigand.
To test and confirm the operations of the CTE and RS-485 reader, try the following steps.
CTE to MT-485 reader connection is o...
Schlage Commercial » Schlage Electronics | Schlage Commercial » Electronic Locks » CTE
CTE Power
The CTE can be powered with POE, POE+, +12 volt DC line input or +24 volt DC line input The CTE has power indicator LEDs that show which power is being applied. The CTE will consume 200 ma ...
Schlage Commercial » Schlage Electronics
How to factory reset a CTE?
The CTE has mode indicator LEDs that show what mode the CTE is in, FDR mode, Construction Mode, or Commissioned mode.
To FDR the CTE, remove the cover
1) Push and hold down the CTE FD...
Schlage Commercial » Schlage Electronics