Category: Schlage

(Results from 81 to 90)
What are the part numbers for the ND lock spring cages?
ND-series locks manufactured before January 30, 2017 used the following spring cages:...
Schlage Commercial » Mechanical Locks » Cylindrical » ND Series » Schlage | Schlage Commercial » Schlage
What Schlage cam will operate Sargent locks?
Click here for a list of available Schlage cams comparable to the Sargent 13-0660. ...
Schlage Commercial » Key Systems » Cylinder Mechanism » Schlage | Schlage Commercial » Schlage
Will the 80-033 fit in a AL lock?
The 80-033 will fit in an AL lock, but will be supplied uncombinated. Pins and springs are not supplied....
Schlage Commercial » Key Systems » Cylinder Mechanism » Schlage | Schlage Commercial » Mechanical Locks » Cylindrical » AL Series - Discontinued » Schlage | Schlage Commercial » Schlage
How do you convert a L9080 to a L9070?
If swapping out complete lock case is not an option and you would like to convert components in the lock case this would void the warranty. See here for required parts....
Schlage Commercial » Mechanical Locks » Mortised » L9000 Series » Schlage | Schlage Commercial » Schlage
What are the part numbers for the mounting posts and screws for an L9000 lock?
 Mounting Posts   Part Number  Door Thickness  L583-211  1 3/8"  L583-212  1 3/4" - See note section on SL1 trim  L583-213  2" ...
Schlage Commercial » Mechanical Locks » Mortised » L400 Series » Schlage | Schlage Commercial » Mechanical Locks » Mortised » L9000 Series » Schlage | Schlage Commercial » Mechanical Locks » Mortised » LV9000-Series » Schlage | Schlage Commercial » Schlage
What is the standard FSIC mortise housing with a straight cam?
20-059 is the standard straight cam FSIC housing only used with Von Duprin, Monarch, and other straight cam applications. 30-032 is the straight cam FSIC housing only for the outside of the Schl...
Schlage Commercial » Key Systems » Cylinder Mechanism » Schlage | Schlage Commercial » Mechanical Locks » Mortised » L9000 Series » Schlage | Schlage Commercial » Schlage
Does the Schlage SFIC rim housings accept both 6 and 7 pin IC cores?
The Schlage small format interchangeable core rim cylinders 80-329, 80-159, 80-116, and 08-129 can accept 6 pin and 7 pin small format cores....
Schlage Commercial » Key Systems » Cylinder Mechanism » Schlage | Schlage Commercial » Schlage
How to connect BE 367 into HHD?
HD /SUS  must be in serial communication mode. Tap icon at right of the  banner " no device connected". It should show the image of a 9 pin D connector for serial communication.once this has...
Schlage Commercial » Electronic Locks » Offline » CM Series » Schlage Electronics | Schlage Commercial » Mechanical Locks » Portable » CL Series » Schlage | Schlage Commercial » Schlage
How is the ND170 installed?
To install a Schlage ND170 click here for the installation instructions....
Schlage Commercial » Mechanical Locks » Cylindrical » ND Series » Schlage | Schlage Commercial » Schlage
What was the part number for the old D series levers spring cage?
The old D series springcage part numbers are as follows: C303-035 - Inside Springcage C303-036 - Outside Springcage These parts are no longer available....
Schlage Commercial » Schlage