Category: Von Duprin

(Results from 41 to 50)
What causes the 6100/6200 series strike not to unlock when power is applied?
1. Measure the voltage at the strike and make sure 12/24VDC (not AC) is present at the strike. A regulated, filtered DC power supply should be used. 2. Make sure there is no load against th...
Schlage Commercial » System Components » Electric Strikes » 6000 Series » Von Duprin
Can the 4854 mullion be ordered as prepped for two 6111 electric strikes?
There is not enough room to install two 6111 electric strikes back to back in 4854 mullion....
Schlage Commercial » System Components » Electric Strikes » 6000 Series » Von Duprin
Will the 6210 FSE DS operate if the DS switch is not used?
The 6210 electric strike will lock/unlock even if DS option is not used....
Schlage Commercial » System Components » Electric Strikes » 6000 Series » Von Duprin
How is the 6211 ordered for a wood frame?
Specify 6211WF for a wood frame....
Schlage Commercial » System Components » Electric Strikes » 6000 Series » Von Duprin
Can 24 volts be run to a 12 volt 6000 series electric strike solenoid?
You can't run 24VDC into the 12VDC electric strike, over voltage such as this will cause the solenoid to heat up and damage the solenoid.  You must change to a 24V solenoid, part number 050240-00....
Schlage Commercial » System Components » Electric Strikes » 6000 Series » Von Duprin | Schlage Commercial » System Components » Electrified System Component Accessories » Rectifier » Von Duprin
Will the Von Duprin 6210 electric strike operate with the MA series locks?
The Von Duprin 6210 electric strike was designed for retrofit applications and will not work with the Falcon MA series lock when strike and lock body are mounted at standard locations (centerline of...
Schlage Commercial » Mechanical Locks » Mortised » MA-Series » Falcon | Schlage Commercial » System Components » Electric Strikes » 6000 Series » Von Duprin
Is there a RX switch for the 6000 electric strikes?
The only switches available for the 6000 electric strikes are the DS Dual Switches.  In the Dual Switch configuration one switch monitors the strike pocket, presumably is the latch bolt inse...
Schlage Commercial » System Components » Electric Strikes » 6000 Series » Von Duprin
What is the device backset when using a 1790 with a 6111 strike?
The Von Duprin 6111 electric strike would work with DOM 1790 device on medium style doors Centerline of the 1790 device mounting screws are located 1 11/16" from face of stop. See draw...
Schlage Commercial » Exit Devices » Touch Bar » 1790 Series » Falcon | Schlage Commercial » System Components » Electric Strikes » 6000 Series » Von Duprin
Can you use a 6211 instead of 6211WF on a wood frame?
The 6211WF is required on a wood frame....
Schlage Commercial » System Components » Electric Strikes » 6000 Series » Von Duprin
Is a rectifier needed to change AC to DC on Von Duprin 6000 series electric strikes?
The strike will always be DC.  By using a SO24 or SO12(rectifiers) you will be able to convert the AC waveform from a transformer to a DC waveform that will be acceptable by the 6000 series strikes....
Schlage Commercial » System Components » Electric Strikes » 6000 Series » Von Duprin

Support by product