What credential readers can I use with a CT5000?
You can use the MTK15 and the SEKPD88
The older KP70+ Series keypad is NOT compatible with the CT5000.
The CT5000 requires that keypad data be transmitted in 2-wire Wiegand (Data1/D...
Schlage Commercial » Electronic Locks » Networked » AD 400 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics | Schlage Commercial » Readers » Keypad Readers » Essex Keypads » Schlage Electronics | Schlage Commercial » Readers » Keypad Readers » KP Series » Schlage Electronics | Schlage Commercial » Readers » Magnetic Stripe Readers » CR Series » Schlage Electronics
How to set up the XceedID keypad reader as a 26Bit wiegand output?
Follow the steps below to make the reader an SFX2110 reader a card or pin.
Step1: Power cycle the reader
Step2: Within 1 minute from power on perform one of the following task: Enter * 8 8 8 ...
Schlage Commercial » Readers » Keypad Readers » Essex Keypads » Schlage Electronics | Schlage Commercial » Security Management » Schlage Electronics
Is the KTP-162 reader used with the CT-5000?
The KTP-162 can't be used by itself as a stand alone access control device.
The KTP-162 is an 8 bit word output keypad, so it just sends keypad number signals to a stand alone controller or ...
Schlage Commercial » Electronic Locks » Standalone/Offline | Schlage Commercial » Readers » Keypad Readers » Essex Keypads » Schlage Electronics