Category: Von Duprin

(Results from 81 to 90)
What exit device is weather rated?
Exit devices are not designed for exterior application. If used in an exterior applications then a powder coated finish on the 33/35 and 98/99 series are recommended for exterior applications. The...
Schlage Commercial » Exit Devices » Touch Bar » 33A/35A Series » Von Duprin | Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin | Schlage Commercial » Exit Devices » Touch Bar » Guard X » Von Duprin
Does Von Duprin have a fire latch that will go into the floor?
Auxiliary fire latch is tested only from door to door latching by Von Duprin. Some door manufacturers have tested our devices LBR and use additional fire latches to pass the fire test. Contact the doo...
Schlage Commercial » Exit Devices » Touch Bar » 22 Series » Von Duprin | Schlage Commercial » Exit Devices » Touch Bar » 33A/35A Series » Von Duprin | Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin
Can the Schlage Latitude levers be used with the 98/99 series?
The Schlage Latitude levers can't be used with Von Duprin 98/99 series exit devices....
Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin
What does a red flashing light indicate on the Von Duprin QEL exit device?
Devices shipped prior to December, 2014:Red flashing light on Von Duprin QEL exit device means no communication. Following could cause the QEL device not to communicate.Make sure the power s...
Schlage Commercial » Exit Devices » Touch Bar » 33A/35A Series » Von Duprin | Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin | Schlage Commercial » Power Supplies » Standard » PS900 Series » Von Duprin
Can a Von Duprin 3' pushpad exit device be converted to a 4' device in the field?
A 3' exit device cannot be converted to a 4' exit device. You will need to replace the 3' device with a 4'. Conversely, a 4' device cannot be converted to a 3' device. Converting these exit devic...
Schlage Commercial » Exit Devices » Touch Bar » 22 Series » Von Duprin | Schlage Commercial » Exit Devices » Touch Bar » 33A/35A Series » Von Duprin | Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin
Is the CX and LBR options available on a 9847?
You can specify Chexit CX98/9927-LBR or CX98/9947-LBR exit devices. If your door is fire rated you will use the AFL, Auxiliary Fire Latch provided with exit device.   ...
Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin
Does Von Duprin offer replacement QEL motors?
See below for part numbers:  114317-00 QELA Mod. Conv. Kit 040061-00 QELA Mod. Conv. Kit w/Connectors 958002-00 HD-QELA Mod. Conv. Kit 040062-00 HD-QELA Mod....
Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin
How do I replace an E996L solenoid?
Order E-Trim Mech Kit  part #050671-00 which will include a new solenoid already mounted to the blocking mechanism. See installation instruction # 921297 here which will show how to remove blocki...
Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin | Schlage Commercial » Von Duprin
Why is my Von Duprin CX going into a weak alarm after the rearm delay?
Chexit devices shipped prior to 8-24-2015 with solenoid - the solenoid pulls and drops, the alarm sounds, there is a solid LED or no LED light after the rearm time...
Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin
Why is the Von Duprin exit alarm ALK going into alarm on it's own?
The following may cause the ALK to go into alarm: Make sure red and blue wires on the RX switch are connected to the exit alarm ALK terminal block and yellow wire is taped off. Check the red and...
Schlage Commercial » Exit Devices » Touch Bar » 22 Series » Von Duprin | Schlage Commercial » Exit Devices » Touch Bar » 33A/35A Series » Von Duprin | Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin