Category: Von Duprin

(Results from 1 to 10)
What is the part number for the Schlage thumbturn rim cylinder?
The rim cylinder with thumbturn, XB11-979 (Figure 1) was designed to be installed on the inside head of the Von Duprin 98/99–2 double cylinder exit devices, see Figure 1. The rim cylinder with ...
Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin | Schlage Commercial » Key Systems » Cylinder Mechanism » Schlage
What products are available with an antimicrobial finish?
DESCRIPTION: The antimicrobial coating is specially formulated to inhibit the growth of bacteria by interrupting cell multiplication. The result is that the silver ions surround bacterial cells, blo...
Schlage Commercial » Exit Devices » Recessed » 94/95 Series INPACT » Von Duprin | Schlage Commercial » Exit Devices » Touch Bar » 33A/35A Series » Von Duprin | Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin | Schlage Commercial » Mechanical Accessories » Push & Pull Plates » Ives | Schlage Commercial » Mechanical Locks » Cylindrical » AL Series » Schlage | Schlage Commercial » Mechanical Locks » Cylindrical » D Series » Schlage | Schlage Commercial » Mechanical Locks » Cylindrical » ND Series » Schlage | Schlage Commercial » Mechanical Locks » Deadbolts » B Series » Schlage | Schlage Commercial » Mechanical Locks » Mortised » L9000 Series » Schlage | Schlage Commercial » Mechanical Locks » Mortised » LV9000-Series » Schlage | Schlage Commercial » Ives
Why doesn't full rotation of the AD or CO Series Exit Trim (993) outside lever fully retract the Von Duprin 98/99 Exit Device latch?
- AD Series and CO series products require that the Night Latch (NL) screw is installed in the exit device.  Be sure this screw is installed- Exit hardware and strike must be properly mounted to ...
Schlage Commercial » Electronic Locks » Networked » AD 300 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Networked » AD 400 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » CO 100 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » CO 200 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » CO 250 Series » Schlage Electronics | Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin
Is there a kit to install the Von Duprin 9847 on an aluminum door when there is no place to attach the top or bottom latch to the door?
Von Duprin does not make a kit to help mount the to top and bottom latches. The aluminum door supplier or the installer will supply this material....
Schlage Commercial » Exit Devices » Touch Bar » 33A/35A Series » Von Duprin | Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin
When were 313AN & 315AN anodized finishes changed to SP313 (695) and 622 powder coat finishes?
Beginning December 6, 2010, all 33A, 35A, 98 & 99 devices ordered as 313AN Anodized was furnished in SP313 (dark brown powder coat).  All devices ordered as 315AN wil...
Schlage Commercial » Exit Devices » Touch Bar » 33A/35A Series » Von Duprin | Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin
CX will not arm. Red light on solid waits 10 sec, light goes out and cycle repeats
Inadequate power or wrong gauge wire is used.  The inrush current demand by CX will overload and shutdown the power supply if undersized.  You must use the Von Duprin PS873 or ne...
Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin
What could cause the Von Duprin EL solenoid not to hold when mechanism cover plate is slide over the solenoid?
If mechanism cover plate causes the EL solenoid to drop when slid over the solenoid, the solenoid plunger requires adjustment.  You must lengthen the rod by turning the hex nut in front of the...
Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin
Why should you use the LX switch with an ALK being used in Von Duprin surface vertical rod devices?
You should use the LX switch with the Von Duprin surface vertical rod exit device because the rods are exposed and are vulnerable to attack. IE, the top rod can be grasped and forced down to retrac...
Schlage Commercial » Exit Devices » Touch Bar » 22 Series » Von Duprin | Schlage Commercial » Exit Devices » Touch Bar » 33A/35A Series » Von Duprin | Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin
Customer has existing EL99 x CM993HW x PS873-2, They now want to add a pushbutton to allow entry from outside. How does it get wired?
Push button gets connected to the input of the PS873-2 power supply (SC & I1)....
Schlage Commercial » Electronic Locks » Offline » CM Series » Schlage Electronics | Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin | Schlage Commercial » Power Supplies » Standard » PS900 Series » Von Duprin
Von Duprin Chexit device keeps going into alarm by itself.
Chexit devices shipped with motor after 8-24-2015. 1. When Chexit device is set for more than zero second rearm time (factory setting is 10 second rearm time) and device goes into alarm immediately t...
Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin