How long will it take for a coin cell to deplete.
The coin cell can last up to 30 days when the AA batteries are not present or are depleted. If the AA batteries are installed and are above 3.7 VDC (or so), the coin cell is not being used at all....
Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics
Resetting AD series lock back to Factory Default
1. Remove the top inside cover.
2. Press and hold Schlage button until two (2) beeps sound ( appx 10 seconds).
3. Release the Schlage button.
4. Press and release the inside push button (IPB) th...
Schlage Commercial » Electronic Locks » Networked » AD 400 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics
What type of coin cell is used in the AD / CO Lock?
The coin cell for the AD and CO family of electronic lock products is a 3vdc lithium. CR2025 is the specified part number....
Schlage Commercial » Electronic Locks » Networked » AD 400 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » CO 200 Series » Schlage Electronics
What template should I use with a 99 device and AD-400 trim on a hollow metal door?
Use the 98/99 & 98-F/99-F NL Series Rim Template. Template Number: 10301 ...
Schlage Commercial » Electronic Locks » Networked » AD 400 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » CO 200 Series » Schlage Electronics | Schlage Commercial » Exit Devices » Touch Bar » 98/99 Series » Von Duprin
Can I set up the CT5000 to remotely unlock a door?
When the switch changes state (e.g., from open to closed), the CT5000 will change the state of the Strike relay....
Schlage Commercial » Electronic Locks » Networked » AD 400 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics
How do I wire full duplex RS485? RS 485
Full Duplex 4 wire hook up rules;
If you must use four wire rather than two wire Half-Duplex.
1. Remember to remove the shorting blocks on the AD300 for “Full Duplex” 4 wiring. This sets the ...
Schlage Commercial » Electronic Locks » Networked » AD 300 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Networked » AD 400 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics
What should I do if the CT5000 USB cable gets disconnected during a firmware update?
If the SUS has timed out (after a few seconds), do the following:
Reconnect the USB cable;
When communication has been re-established, Select "Device Options" at the bottom of the Schlage Ut...
Schlage Commercial » Electronic Locks » Networked » AD 400 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics