Category: Schlage Electronics

(Results from 81 to 90)
Can I set up the CT5000 to remotely unlock a door?
When the switch changes state (e.g., from open to closed), the CT5000 will change the state of the Strike relay....
Schlage Commercial » Electronic Locks » Networked » AD 400 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics
How do I wire full duplex RS485? RS 485
Full Duplex 4 wire hook up rules; If you must use four wire rather than two wire Half-Duplex. 1. Remember to remove the shorting blocks on the AD300 for “Full Duplex” 4 wiring. This sets the ...
Schlage Commercial » Electronic Locks » Networked » AD 300 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Networked » AD 400 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics
I replaced the CT5000 coin cell, but I still get a Low Battery indication.
Coin Cell part number is CR2025 - 3Volt Lithium - available at most any battery store....
Schlage Commercial » Electronic Locks » Networked » AD 400 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics
What should I do if the CT5000 USB cable gets disconnected during a firmware update?
If the SUS has timed out (after a few seconds), do the following: Reconnect the USB cable; When communication has been re-established, Select "Device Options" at the bottom of the Schlage Ut...
Schlage Commercial » Electronic Locks » Networked » AD 400 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics
Can the CT5000 be powered by AA alkaline batteries?
The power supply must be able to source enough current for the CT5000 (500 milliamps) plus any additional devices (electric strike, mag lock, etc.) connected to the CT5000....
Schlage Commercial » Electronic Locks » Networked » AD 400 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics
What is the maximum number of users on an AD-200 lock
AD-200 5000 users, 5000 audits CO-100 500 users CO-200 2000 users 2000 audits KC-2 1000 users, 1000 audits CM (Silver) 1000 users, 1000 audits...
Schlage Commercial » Electronic Locks » Networked » AD 400 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Networked » VIP Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Networked » WA Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » CL Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » CM Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » CO 200 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » King Cobra Series » Schlage Electronics
Are the AD and CO handles interchangeable Can AD locks can be put on a CO lock Can CO handles can be put on an AD lock
The AD and CO levers are interchangeable...
Schlage Commercial » Electronic Locks » Networked » AD 400 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » CO 200 Series » Schlage Electronics
Why doesn't the cover depress the Tamper Switch on my Main PCBA?
The Main PCBA and Inside Cover were revised to incorporate a more robust switch in a different location on the board. See the attached document, Tamper Switch and Cover Comparison , for a compari...
Schlage Commercial » Electronic Locks » Networked » AD 300 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Networked » AD 400 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics
Which AD firmware package version supports WRI400/CT5000 devices?
SUS 4.4.0 released on 06/06/2011 is the first released SUS version compatible with WRI400 and CT5000 devices....
Schlage Commercial » Electronic Locks » Networked » AD 400 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics
Why can't I see the Lock Friendly name in the Hand Held Device (HHD)?
In order for the HHD to be able to display the lock name, the lock firmware must be updated with ADFwPkg 2.17.10 and COFwPkg 1.21.0 (OR higher) AND the lock MUST be programmed with its door file befor...
Schlage Commercial » Electronic Locks » Networked » AD 400 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » AD 200 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » CO 200 Series » Schlage Electronics | Schlage Commercial » Electronic Locks » Offline » CO 250 Series » Schlage Electronics