Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Can you field convert a standard 996 lever trim to an RX996 trim?

Resolution: No, a field conversion is not possible. A new trim would be required. The RX996 trim is shipped complete from factory.:

Are CS210 locks handed?

Resolution: During the installation process the chassis and latch can be oriented in either direction to accommodate any hand or swing of door. Certain lever designs are handed, but they are field reversi...:

Are Schlage S200 locks handed?

Resolution: The video How to Hand the S200 Series may be helpful.:

Are Schlage LT locks handed?

Resolution: During the installation process the chassis and latch can be oriented in either direction to accommodate any hand or swing of door. The design of the LT lock allows the inside and outside lev...:

Are Schlage S locks handed?

Resolution: During the installation process the chassis and latch can be oriented in either direction to accommodate any hand or swing of door. Certain lever designs are handed and cannot be changed in the fie...:

Are Schlage HL6 products handed?

Resolution: During the installation process the chassis and latch can be oriented in either direction to accommodate any hand or swing of door. For HL6 L9000 functions handing for the lock case ca...:

Can a hinge pin door stop be used on a 5BB1?

Resolution: The residential hinge pin door stops, 69, 70, 72, & 73, cannot be used with commercial butt hinges like the 5BB1 or the 3PB1 (or any of them.) While the pin diameter on our commercial hin...:

Who can be contacted for Spextra support?

Resolution: Phone- (888) 372-7732Email- [email protected]:

Are there alternative solenoids for ES6400 with different amperage ratings?

Resolution: NO. ES6400 power requirement is as follows. 12 VDC @ Continuous Duty @ .375 Amps*24 VDC @ Continuous Duty @ .190 Amps*12-24 VAC Intermittent Duty @ .280-.565 Amps** Ratings based on max ...:

What is the part number for the SFIC driver and spacer for an AD200 lock?

Resolution: The part number for the SFIC driver is 23446347 and the SFIC spacer is D500-000.: