Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

What is the actual door size of a Republic Embossed Door?

Resolution: The door is undersized from the nominal size by 1/4" in width and 7/8" in height.:

What is the standard undercut on a Republic Embossed Door?

Resolution: The standard undercut is 3/4".:

What hinge edge reinforcements are available for the Republic Embossed Doors?

Resolution: The hinge edge is non-beveled and reinforced with a continuous 16 gauge steel channel (with an optional 10 gauge available for the DE Series) that is projection welded at a maximum of 5" on center....:

Can the B661P be ordered for an extended door dimension over 2 inches?

Resolution: The B661P can be ordered from the factory to fit up to a 2 ½" door thickness at no extra cost. For an existing installation, there is not an extended door parts kit for doors greater than 2" u...:

Falcon TM Series Launch

Resolution: The Falcon TM series was launched June 1, 2026.:

The screws are shearing off the toe on the HSLR trim and the toe falls off.

Resolution: The screws holding the toe to the HSLR trim can break when the toe is forcefully hit by carts or other equipment.:

Is the ALX offered with RX?

Resolution: You can though install an RX switch on the ALX by utilizing the RX kit from the PC series.RX Kit 48260577 can be ordered as a separate itemALX locks used with the RX need chassis spacers on doors l...:

What Schlage cylinders will fit the Falcon 214-KIL trim?

Resolution: Cylinders that will operate the Falcon 214-KIL trim are as follows:Schlage Cylinders23-013 Conventional20-750 Primus20-750-XP Primus XP20-550 Primus UL43720-550-XP Primus UL437 XP Falcon Cylin...:

OWhat does the Latchbolt Switch monitor on the electrified PM mortise lock monitor?

Resolution: The LX switch on the PM series electrified monitors the actual latch, not the AUX latch.:

Are Schlage conventional keys cut bow to tip?

Resolution: Schlage keys for a conventional cylinder will be cut from bow to tip.: