Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

On an AD 300/400 main PCB board there is a separate J12 terminal input, what is that used for?

Resolution: On an AD300 t is used to wire in a battery pack for power if the lock is ever reclassed to an AD 400. The J12 on the AD400 is used to connect the battery cable to the main board.:

In the PIM 400 485 and TD2 models there is a "reader tab" which gives you options to enable or disable card reads. Can you make changes to these settings in the PIM and have them reflect to the AD-400 lockset?

Resolution: You can change reader setting through the PIM on a linked lock, however it is not recommended because it could take up to 10 minutes for the lock to see the change. We always recommend making any c...:

If you place a jumper across SC & I1 momentarily, should that activate the relay on 900 series option boards?

Resolution: Yes, a closure on SC and I1 should activate relay 1 (zone 1) on the 900-4R and 900-4RL option boards. Similarly, on the 900-2RS a closure on SC and I1 will activate O1. You would be able to test by...:

Can the CO series locksets use a turn knob instead of a lever?

Resolution: No, only levers are compatible with the CO series.:

Can the AD series locksets use a turn knob instead of a lever?

Resolution: No, only levers are compatible with the AD series.:

What is the typical construction for Republic lead lined doors?

Resolution: Typical construction based on DL Series door:

What is the lead thickness for Republic lead lined doors?

Resolution: 1/16" standard:

What is the edge seam construction Republic lead lined doors?

Resolution: Visible seam is standard. :

What is the thickness Republic lead lined doors?

Resolution: 1 ¾" (18 and 16 gauge):

Can you reorient the magnet on the Locknetics MG600?

Resolution: The magnet on the Locknetics MG600 cannot be reoriented like some of our other maglocks such as the M400 series. :