Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Can you use a 4040XP EDA closer with a GJ450 overhead stop?

Resolution: For this application (4040XP EDA style arm and GJ450) you would need the 4040XP EDAG closer X ST-2735. If using a Drop Plate with the closer, use the 4040XP-18 Drop plate, ordered separately....:

What is the length of the 2810-168 Slide?

Resolution: The 2810-168 slide length is 11”. For OP arm template, see here.:

Is there a pull side mount Benchmark 9150 available?

Resolution: The Benchmark 9150 is only available as a Push side mount. It is not available in a pull side mount.:

Can you order a 4040XP closer with the Backcheck Selector valve already screwed in?

Resolution: You can order the 4040XP closer x ST-3068 to have the Backcheck Selector Valve already screwed in for parallel arm mounted applications. :

Can you mount the 4000T with the closer on a door and track on the wall?

Resolution: You can use ST-2457 which reverses the mounting of the 4000T where the track is mounted to the wall in a pocket and the closer is mounted on the door. This is only for use on Standard Butt Hi...:

What is the difference between A2 pinning and A4 pinning?

Resolution: Small format interchangeable cores (SFIC) have different pinning systems available to them. These pinning systems consist of specific sets of pin measurements, key cut depths, step increments...:

Can the 284L-4 Strike be used with HH devices?

Resolution: The 284L-4 is a bottom strike for some Von Duprin Panic Rated Surface Vertical Rod exit devices and is used when a threshold is present.The Von Duprin HH (Wind and Impact Rated) and HW (Wind only) ...:

Can you use the ND indicator in exterior applications?

Resolution: The ND indicator was tested and approved for exterior applications. :

Is the 4510 closer available with a hold open arm?

Resolution: There is currently one special (ST-2670) hold open arm available for the 4510 series. This special uses a standard, non-tamper proof hold open arm. This means it will no longer be suited for ...:

How are the Schlage L9000 locks with MLR handed?

Resolution: The Schlage L9500 and L9600 mortise locks, with mortorized/electrified latch retraction, are handed in the same way as the L9000 locks. Handing screw must be on the “inside” side of the lock ...: