Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Does Steelcraft have a maintenance guide for their doors and frames?

Resolution: Steelcraft does not have a maintenance guide for their doors and frames. Steelcraft follows the guidelines recommended by SDI (Steel Door Institute) in document 124-22. This guide can be found on t...:

Does Steelcraft offer a rabbeted door edge on their doors?

Resolution: Rabbeted door edges are not available on Steelcraft doors. Steelcraft only offer beveled edges on most door series except the SL or SZ series doors which have square edges.:

Can you mount a 4040SE pull side with a 4" reveal on a total door system?

Resolution: ST-3351 is used when trying to mount a 4040SE pull side with a maximum of a 4” reveal and a Total Door System. This will work with reveals between 2-11/16” and 4”. It uses a special DE a...:

What is the minimum and maximum reveal for a LCN 5010 closer with reg arm?

Resolution: The minimum reveal is ¾" and the maximum reveal is 2" when using the 5010 closer with reg arm. :

Does the LCN 2210 closer have a Hold open option?

Resolution: The LCN 2210(DPS) does not have a hold open / bump / hold open bump track available. The LCN Hold Open clip and bumper, will not fit into the 2210(DPS) track. Also, the 2210 arm will no...:

Where can i find LCN instruction sheets?

Resolution: See here.:

Can the LCN 2800 concealed senior swing operator be used with pocket pivots or swing clear hinges?

Resolution: The 2800 series operator cannot be used with pocket pivots nor swing clear hinges.These hinges have too much rotation and arm does not have enough travel in the door.:

What is the door range for the ALX170 single dummy trim?

Resolution: The standard option for ALX170 is surface mount which will work on door thicknesses down to 1-3/8". With the thru-bolt option kit, the standard door range of 1-3/8" through 1-7/8" is supported...:

How to remove a split key construction insert from a conventional cylinder?

Resolution: See the video “How to remove split key construction insert”. This instruction would also apply to Falcon conventional cylinders that a construction keyed using the split key or Block-O-Key met...:

Are monitoring switches available on L9000 series with XL13-439 key override?

Resolution: L9000 series locks when ordered with the XL13-439 key override feature are not available with monitoring switch options: Request to Exit (RX), Latch Monitoring (LX), Door Position Switch (DPS), or ...: