Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Does Schlage make a KIL cylinder for PDQ locks?

Resolution: Schlage does not offer cylinders for PDQ locks.Schlage KIL cylinders may fit a PDQ lock but Schlage does not make a tailpiece to operate a PDQ lock.:

Can the electrified MA handing be changed?

Resolution: The Request to Exit (RX) on the MA851 or MA881 monitors both sides and does not require Rehanding.:

What plug is used in conventional Schlage mortise cylinders?

Resolution: Schlage conventional rim and mortise cylinders use same plug(s) with anti-drill pins. For Classic keyways, the plug part number is 33-167For Everest and Everest 29 keyways, the plug part numbe...:

Is Brinks a Schlage Partner?

Resolution: Brinks is not an approved Schlage partner, and Schlage cannot guarantee a successful connection with Brinks products.To view a list of approved Schlage partners, please click here.:

Will the N523-091 SFIC driver for the ND series work with the AD/CO series?

Resolution: The ND series SFIC driver (N523-091) has a blade length of 0.97".The AD/CO series SFIC driver (23446347) has a blade length of 0.71":

Does LCN offer a double pole double throw activation device?

Resolution: All LCN actuators are a single pole double throw switch, LCN does not offer a double pole double throw actuator.:

Can LCN drop plates be order with SRI?

Resolution: LCN does offer SRI on drop plates. The plate will be stamped with SRI on the plate as well if it has SRI pre-finish.:

Does Steelcraft have an online ordering tool?

Resolution: Steelcraft does have an online entry tool called OEW (Order Entry Works). This tool is for distributors of Steelcraft products only. If you are a distributor, please contact your local sales rep to...:

Installation troubleshooting guide for steel doors and frames?

Resolution: Installation Trouble Shooting Guide 122-21 which can be found on the SDI website under Technical Data Series. See here. :

When you order the LCN sr swing header dress plate, part #9540-334-2, do you get one or two dress plates?

Resolution: When ordering the LCN sr swing dress plate, 9540-334-2, you will get two dress plates, one for each end of the header, plus 8 mounting screws.: