Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Will the N523-091 SFIC driver for the ND series work with the AD/CO series?

Resolution: The ND series SFIC driver (N523-091) has a blade length of 0.97".The AD/CO series SFIC driver (23446347) has a blade length of 0.71":

Does LCN offer a double pole double throw activation device?

Resolution: All LCN actuators are a single pole double throw switch, LCN does not offer a double pole double throw actuator.:

Can LCN drop plates be order with SRI?

Resolution: LCN does offer SRI on drop plates. The plate will be stamped with SRI on the plate as well if it has SRI pre-finish.:

Does Steelcraft have an online ordering tool?

Resolution: Steelcraft does have an online entry tool called OEW (Order Entry Works). This tool is for distributors of Steelcraft products only. If you are a distributor, please contact your local sales rep to...:

Installation troubleshooting guide for steel doors and frames?

Resolution: Installation Trouble Shooting Guide 122-21 which can be found on the SDI website under Technical Data Series. See here. :

When you order the LCN sr swing header dress plate, part #9540-334-2, do you get one or two dress plates?

Resolution: When ordering the LCN sr swing dress plate, 9540-334-2, you will get two dress plates, one for each end of the header, plus 8 mounting screws.:

Does Steelcraft have a maintenance guide for their doors and frames?

Resolution: Steelcraft does not have a maintenance guide for their doors and frames. Steelcraft follows the guidelines recommended by SDI (Steel Door Institute) in document 124-22. This guide can be found on t...:

Does Steelcraft offer a rabbeted door edge on their doors?

Resolution: Rabbeted door edges are not available on Steelcraft doors. Steelcraft only offer beveled edges on most door series except the SL or SZ series doors which have square edges.:

Can you mount a 4040SE pull side with a 4" reveal on a total door system?

Resolution: ST-3351 is used when trying to mount a 4040SE pull side with a maximum of a 4” reveal and a Total Door System. This will work with reveals between 2-11/16” and 4”. It uses a special DE a...:

What is the minimum and maximum reveal for a LCN 5010 closer with reg arm?

Resolution: The minimum reveal is ¾" and the maximum reveal is 2" when using the 5010 closer with reg arm. :