Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

What strike is used with the L9000 series on a 1-3/4" door with an overlapping astragal?

Resolution: The 10-072 078 (7/8" flat lip) strike is used with the L9000 series on a 1-¾" door with an overlapping astragal.:

How do you order LCN finish samples?

Resolution: LCN finish samples can be ordered. Please refer to the below for the recommended parts to order per type of finish desired. Current pricing applies. Contact your local Allegion Sales Office o...:

Why won’t my LCN receiver and transmitter program?

Resolution: Couple things to check:Make sure both the receiver and transmitter are the same frequency. (433 mhz, 900 mhz)Check to see that there is a clear line of site between transmitter and receiver antenna...:

Can the 4040XP with CUSH arm be used with Soss/Tectus hinges?

Resolution: The 4040XP Cush closer can be used on a door hung on soss invisible hinges. You would just take your measurements for mounting the closer body and arm from the centerline of the hinge, with door in...:

Where can I find the LCN Catalog?

Resolution: You can find all the LCN catalog sections here.:

Does Von Duprin offer a filler plate to cover the 6111 prep on the 4854 mullion?

Resolution: Von Duprin does not offer a filler plate for the electric strike prep.:

Does Schlage home require a subscription to use?

Resolution: The Schlage home app does not require a subscription.:

What closer reinforcements (optional) are available on the Republic DL series door?

Resolution: Closer reinforcement – 14 gauge 18" x 6" (Optional 12 gauge):

What face skins are available on the Republic DL series door?

Resolution: 20 gauge, 18 gauge, 16 gauge, or 14 gauge (DE Series) (cold rolled steel or A60 galvannealed)− G90 Galvanized available in 16 or 14 gauge only:

What type of bottom channel is available on the Republic DL series door?

Resolution: Bottom channel is an inverted16 gauge steel channel, projection welded at a maximum of 2-1/2" on center: