Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Can IVES Lock Guards be used on double doors?

Resolution: Ives lock guards are designed for use on for double doors with an astragal and not for use on single doors. Ives Lock Guards sit flush against the doors in a double door application.&nbs...:

What is the difference between the FB457 and the FB458?

Resolution: The FB457 and FB458 are very similar. The only difference between the two is the width of the face plate. The FB457 face plate is 1.25" x 6.75" while the FB458 face plate is 1" x 6.75":

Can a Bar Coordinator be used with Offset Pivots?

Resolution: There is a small chance that this combination could work, but it often does not work properly. Because of the location of the pivot point, the active door lever of a Bar Coordinator (COR32, C...:

Why are the 900-4RL option board red and green lights flashing in an alternating manner?

Resolution: If the SW2 dipswitches are improperly both set to ON, the red and green lights will strobe to indicate an error. See the 900-4RL instructions to properly set SW2. :

How do I order a shim kit for a Falcon 24 or 25 series concealed rod exit device?

Resolution: 24-C just use the 24 C shim kit. To make this work need you need a new center slide with extended tab, part# 81-038-00 for 1/4" thru specials engineering. and 2 1/4" screw pkg. ...:

Can the 98/9947WDC or 98/9950WDC device be paired with a 98/9975 mortise lock device?

Resolution: The 98/9975 exit device requires a strike to be mounted to locking edge of the other door leaf in a paired opening. It is not possible to mount a strike on the door with a 98/9947WDC or...:

What is the bore hole size for the AL and ND series latches?

Resolution: Depending on the latch selected for use with the AL or the ND series. Both the AL and ND series would require a 7/8" or 1" bore for the latch, depending on latch selected. Please check ...:

What is the width of the Camelot and Plymouth Escutcheon for the CS200 series?

Resolution: The width dimension of the Camelot and Plymouth Escutcheon is 3.35 inches wide.:

Will the Schlage B520-295 cam work on a Falcon cylinder?

Resolution: The B520-295 Schlage cam could be used on the below cylinders if required. Must be ordered separate. 985 986 987 988 990 992 :

How far does the 22 series center case cam have to rotate to fully retract the latch bolt?

Resolution: :