Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Is the electrified L9000 PCB still available?

Resolution: The electrified L9000 PCB (L283-344) is no longer available and there is no replacement. Complete lock chassis must be ordered.:

What is the minimum height of a 377T used with an 8827 or 8827-F device?

Resolution: With the 8827 or 8827-F device mounted at the standard centerline of 39 13/16" above the finished floor, the centerline of the thumbturn can be located at 46 1/2” above the finished floor minimum.:

Can the Schlage D-series be converted from conventional cylinder to full size interchangeable core?

Resolution: Using kit 04-030, you can convert the Schlage D-series from a conventional cylinder prep (PD) to a full size interchangeable core prep (JD). Using kit 04-034, you can convert the S...:

What size security bit would be used with the X Mount option?

Resolution: The X Mount security mounting option for Ives pulls is a "pin in star" design that is 5/16" diameter with an 1/8" pin in the middle.:

What mortise cam operates the Emtek 3300 series mortise lock from Assa Abloy?

Resolution: The Emtek mortise entrance locks (3300 series) use the A92 mortise cam. Schlage does not offer an equivalent mortise cam.:

Does the ND series fall under the UL305 testing?

Resolution: The ND series cylindrical are not tested to the UL305 as this applies to Panic Hardware.:

Can the 4040(XP)-384 stop be used in a 4050A Cush arm?

Resolution: Yes.:

What material are the ND levers made of?

Resolution: ND lock levers are made of pressure cast zinc. :

Does the Von Duprin Chexit 98/9927 Surface Vertical Rod exit device require rod guards?

Resolution: Does the Von Duprin Chexit 98/9927 Surface Vertical Rod exit device require rod guards? Yes, this device requires rod guards as pulling down and lifting up on the surface vertical rods can by...:

Can the Von Duprin 996 lever trim accept an RX switch?

Resolution: Can the Von Duprin 996 lever trim accept an RX switch? Yes, the RX switch can be ordered for the Von Duprin 996L lever trim but it must be ordered complete from the factory. There is no...: