Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Are the CO series locksets BAA compliant

Resolution: No, they are not. However, the AD series locks are BAA compliant.:

Is there a template for the MLBK600 bracket?

Resolution: No, there is no template for the MLBK600. Only installation instructions. You are to use the bracket as a template.:

Is there a template for the MZBK600 bracket?

Resolution: No, there is no template for the MLBK600 for MG Series Maglocks. Only installation instructions. You are to use the bracket as a template.:

What is the cover screw size for the Falcon SC80A slim line cover?

Resolution: The size of the SC80A slim line cover screw is 8-32 x ¼.:

Is the auxiliary 62A shoe the same for all closers?

Resolution: The 62A auxiliary shoe from LCN is the same and interchangeable between the different LCN series closers. The Falcon closers have their own version of the 62A auxiliary shoe, which is the same and ...:

Does the 8310-2320 come with gasketing?

Resolution: The 8310-2300 series wave activation device does come with weather resistant gasketing.LCN recommends the weather resistant gasket to be used as a protective barrier against the elements.:

Can the Falcon OHC100 be used with offset pivots?

Resolution: The OHC100 can be used with offset pivots but will need to use the VO arm and will not be double acting.For VO arm instructions see here.:

Can the rods on a FB30 or FB50 be cut/shortened?

Resolution: The standard rods that are supplied with the FB30 and FB50 Series Flush Bolts cannot be cut in the field because they are not threaded the entire lengthIves offers replacement rods that can be used...:

What does the handing look like for a 8300 Series pull plate when the plate is larger than 4" with CFC or CFT cutouts.

Resolution: The standard location as described in the IVES_Architectural_Hardware_Products_Catalog_105313.pdf places the 1 ¼" diameter CFC or 3/8" diameter CFT hole as shown below when the plate is 4" or...:

How can I get a warranty replacement on my DEXTER door closer?

Resolution: For a warranty replacement on any DEXTER door closer the unit must be returned to the original hardware distributor for replacement.: