Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

What sizes are available for the latch faceplates for the ND series locks?

Resolution: See below for the different latches and backsets with their respective faceplate size.Spring latch2-3/4" - Square corner, 1-1/8" x 2-1/4"3 -3/4" - Square corner, 1-1/8" x 2-1/4"Dead latch2-3/8" - S...:

Can a Schlage lock be installed sideways in order to have a top leaf latch into the bottom leaf of a Dutch door?

Resolution: Schlage locks are not a recommended solution for latching a top leaf directly into a bottom leaf of a Dutch door. For Fire Rated Dutch DoorsSchlage locks are not tested for installation 90 de...:

Is there a special template to use for the LCN 2610 and surface-applied overhead stop?

Resolution: ST-2511 is a special template used for compatibility between GJ 70, 79,80, 90, and 450 series surface-applied overhead stops. :

What is the mounting footprint for the LCN 1460 cylinder?

Resolution: 1" X 7.5" :

Is there a recommended distance between a senior swing and a remotely mounted control box?

Resolution: This distance should be within a distance where our standard wire connections (plugs) can reach without being modified.:

Can the sr swing header be cut down in the field?

Resolution: We would not recommend doing this but if it is a single door header you can physically cut it down. Just make sure the end that is cut is the control box end not the motor end and minimum it should...:

Can the Sr Swing concealed operator work with concealed vertical rods?

Resolution: You can use concealed vertical rods with the 2800 series concealed operator with special templates and must use OP arms, no center pivots. If using a double door 2810DD/MP, 2850 or 2860 you would o...:

Will an ND series latch replace a D series Latch?

Resolution: The Schlage D-series 14-001 spring Latch was replaced with the 13-248 spring Latch. The 14-019 deadlatch was replaced with the 13-247 deadlatch. :

What is ST-0651 from LCN?

Resolution: ST-0651 is for the use of Offset Pivots (by others) with the 2030 series concealed closer.:

What is ST-0788 from LCN?

Resolution: ST-0788 is special templating for a 7/8" centerline of track to centerline of closer.: