Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Can AD locks be set to failsafe when no power is to them?

Resolution: The only lock that will change state in a power loss is the AD300 because it has the capacitor on the COM300 board (no power, no motor), the capacitor stores enough voltage to pulse the motor upon ...:

What configuration card is used to reset the MT readers OSDP Secure settings?

Resolution: CE-000-010 is the correct configuration card.:

Can devices on a site ID: xxxxxx work on BluB0X even if the site was not created by BluB0X software?

Resolution: There is no way to do this because of the site key. The only solution is to FDR all the devices (gateways and locks) and commission them to the site that way you create it via the software.:

Does an SI reader read prox cards?

Resolution: No, the Prox chip was removed out of the reader to put the HID chip in.:

Can the CO200 use more than one programming card?

Resolution: No, you only have the option of using one programming card or one programming pin. When you configure a programming card, it disables the programming code. :

Can the AD200 use more than one programming card?

Resolution: No, you only have the option of using one programming card or one programming pin. When you configure a programming card, it disables the programming code. :

What ANSI A156.23 Grade is the GF3000?

Resolution: The GF3000 is ANSI A156.23 E18602 Grade 2.:

What is the difference in sound between the DE alarm and the door propped alert on the M490DE?

Resolution: The sound is the same for both. During a DE alarm the LED will flash red. During a door propped alert, the LED will flash green. :

What type of relays does the CT5000 use, are they solid state?

Resolution: The CT5000 uses standard signal relays.:

Video: Manually Programming an AD200 or CO200 with the Android and SUS cable

Resolution: Video: Schlage SUS-A - Manually Programming Door File to AD-200 or CO-200 - YouTube: