Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

What is the length of the standard 2010 arm?

Resolution: The total length of the 2010-3077T standard arm is approximately 14.”This arm is 13" from Centerline to Centerline.:

What is the length of the standard 2030 arm?

Resolution: The total length of the 2030-3077T standard arm is approximately 14”This arm is 13" from Centerline to Centerline:

Is there a SOSS closing hinge that will work with the 518 series?

Resolution: There is not a invisible closer hinge (IC) that will work with the 518 series of invisible hinges.:

Can you mount a 4630 on a 32’ door?

Resolution: You can use ST-3070 to mount a 4631 on a 32” door. This will give the unit a 100 degree power opening and the closer must be able to hang over the frame face at the hinge edge of the door. &n...:

Can I use a on/off switch with the 4040SE closer?

Resolution: You would wire the NC/COM contact of the on/off switch you are using, to one leg of the incoming power - if the switch opens, power is broken and the solenoid will release the hold open.:

Can a 4040XP pull side mount closer clear a 6" side wall?

Resolution: For a 4040XP to be mounted pull side and clear a 6” side wall you will need to use ST-3146. This application uses a special arm as well as special templating. Please Note: This application wi...:

What is the part number for the 4040XPT shaft spacer?

Resolution: 4040XPT-61 is the part number for just the shaft spacer. This part can be ordered separately. :

4040XP Top Jamb mount with Offset pivots?

Resolution: Locate closer and shoe from centerline of the Offset pivot.See here for installation instructions.:

Can you use a 4000T on a 24" door leaf?

Resolution: You can use ST-2438 to make a 4000T work on a 24” door with pocket pivots or if using butt hinges use ST-2438-1. Both STs require special templating as well as special arm and cylinder.:

Is there a special LCN HCush arm with a special t-handle?

Resolution: ST-2468 is a special HCush or Spring HCush arm with the wings removed from the hold open handle and replaced with a ½” hex screw cap. This ST will work for 4110, 4210, 4040xp, 1460, 4030. Thi...: