Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

What is the Schlage equivalent to the Von Duprin 3216 cylinder?

Resolution: The Von Duprin 3216 Rim cylinder is equivalent to the Schlage conventional horizontal tailpiece Rim cylinder 20-022.:

Does the grommet that comes with the Glynn Johnson 100 series Hold open come in different finishes?

Resolution: The grommet that comes with the Glynn Johnson 100 series hold open will always be brass. The knob that sits on the grommet will change with finish ordered:

Can the L9025 be purchased with an escutcheon?

Resolution: The L9025 can be purchased with an escutcheon. :

Do FSIC mortise cams come with screws?

Resolution: Mortise cams are ordered as the cam only, you should re-use the cam screw from the mortise cylinder.:

How to convert ND44 to ND40?

Resolution: You will need to purchase the ND40 outside emergency button and plunger, N123-034 and emergency cylinder N523-020.Remove the outside lever, for assistance see related solution belowRemove the exist...:

Does Von Duprin offer an RX-CON switch kit?

Resolution: Von Duprin does offer an RX-CON switch kit (part 050987) for field installation into a 98/99, 33A/35A, or 22 Series Exit Device.The Molex connector ships loose and must be attached to the crimped w...:

What tailpiece is needed for ND series with use of Falcon SFIC cylinder?

Resolution: With the ND series SFIC using the Falcon SFIC cylinder will use the same tailpiece as the Schlage SFIC.Part number: N523-091Snip it from the Service Manual:

Can you order the tailpiece for CS210 FSIC housing seperate?

Resolution: The CS210 FSIC tail piece part number is S506-894 and is available seperate. :

What is the maximum length for a Rim cylinder?

Resolution: If a total door thickness over 3" is required a special cylinder is required. These are available ranging from 3-1/4" to 7-5/8" and can be found in the “Special Cylinders” section of the Schlage pr...:

What is the locked lever force torque requirement for ND series?

Resolution: Grade 1 cylindrical locks must meet or exceed a requirement of 1200 in-lbs locked lever force torque per ANSI/BHMA A156.2 2011: