Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
FAQs
«
1141
1142
1143
1144
1145
»
Question
Answer
Will the Schlage AD Series Exit Trim work with the Von Duprin 78 Series Exit Device?
Resolution:
The Schlage AD and CO Series Exit Trims will work with several Exit Devices.Please check the appropriate Data Sheet for a compatibility chart for specific Exit Devices.Schlage_AD_Series_Exit_Trim_D...:
How should an EL PWM be wired if the plugs were cut off?
Resolution:
If the plugs on an EL Pulse Width Module (PWM) or the older EL Potted Circuit Breaker (PCB) were cut off, the wires could be stripped and spliced or wire nutted together.The wires on the module are...:
What is the purpose of the 1501 Mercury board for a PIM-485?
Resolution:
The PIM1501 uses the PIM400-485 so all decisions are made within the ACP. The 1501 board just allows the PIM400-485 to connect to the ACP as ethernet instead of RS485 wiring.:
Does the mortise case for the CO100 have a clutch feature?
Resolution:
The CO100 mortise case is like a passage, no clutching feature, no electronics in the mortise case. The clutching is in the outside lever and the outside lever is locked and unlocked in the outside...:
Does the CO100 MD 40 need a DPS installed?
Resolution:
No, however, the mortise case needs to be plugged into the DPS terminal for latch bolt monitoring, the lock needs to see the change of state of the deadbolt to enable the function.:
Using the privacy function on a CO/AD, what led indication do you get on the inside when you press the IPB?
Resolution:
Four quick red flashes around the IPB, then it will flash 4 times green when it goes out of privacy.:
Is the template for the CO220 CY the same as the CO200 CY?
Resolution:
:
Video - Manually Programming a Freeze PIN
Resolution:
Video - Manually programming a freeze PIN: Schlage CO-100, CO-200, AD-200 - Manually Program a Freeze PIN Code (youtube.com):
What are the red and green wires on a Locknetics MG600 DT Magnetic Lock?
Resolution:
This is for the door position switch. It is an open circuit when door is open, and a closed circuit when the door is closed.:
Test Content
Resolution:
Test content:
«
1141
1142
1143
1144
1145
»