Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

What is Schlage part number 47342586 RHO Instruction Rose?

Resolution: 47342586 is the RHO Instruction Rose used on the ND78/98 Classroom Security locks. Arrows show the correct inside cylinder rotation needed to lock the outside lever. It is only available in 626, us...:

Does hard wiring the Schlage L9000 or ND locks void the warranty?

Resolution: As an alternative installation method, the Molex connector may be cut off and the lock installed with traditional wire splicing methods, and does not affect the warranty. :

Does Schlage Offer Replacement Wires for Electronic Locks?

Resolution: No, Schlage does not offer replacement wires for its electronic locks, including smart locks. The wiring in Schlage electronic and smart locks are not considered replaceable parts. If you experienc...:

Can Schlage Encode Series Locks Be Hardwired to Extend Battery Life?

Resolution: No, the Schlage Encode Series locks cannot be hardwired to extend battery life. Attempting to modify these electronic locks for hardwiring will void the warranty. :

Can you mount the 4510T closer on a double egress frame?

Resolution: The ST-2640 can be used for a 4510T double egress application if the reveal is 3 5/16” or less. PLEASE NOTE: ***THIS APPLICATION MAKES THE UNIT A NON-HIGH SECURITY CLOSER BECAUSE IT USES THE 4...:

Can you use the 8310-806K(R) three position switch with the 6440XP?

Resolution: The 8310-806K and 8310-806R switches will not work with the 6400 Compact Operator. This unit does not have an indefinite hold open feature, nor will it hold open indefinitely if you send a co...:

Is the 1250-146 shaft cover the same as the 1450-146 shaft cover?

Resolution: The shaft cover is the same for the 1250 and 1450 series:

When did the LCN 4050 closer change to the 4050A?

Resolution: The 4050 changed to the 4050A on Jan. 1, 2020. The cylinders are exactly the same, but the 4050A arms are different (different templating).:

What is the Torx screw bit size for LCN High Security closers?

Resolution: Special driver bits are required for installation or removal of Torx Machine Screws with a security pin as supplied with LCN High Security closers. All bits fit a 1 ⁄4" hex drive socke...:

Will the Schlage Encode Work with a 3-Point Locking Door (Hurricane Door)?

Resolution: The Schlage Encode Smart Wi-Fi Deadbolt is not recommended for use with 3-point locking doors, also known as hurricane doors. Installing the Encode or Encode Plus on a multi-point locking system ca...: