User questions

Question
Answer
  • What could cause the Von Duprin EL solenoid not to hold when mechanism cover plate is slide over the solenoid?
  • Does EL conversion kit for Von Duprin exit devices contain mechanism cover plate?
  • What is the part number for the ND solenoid?
  • What Von Duprin solenoid crosses over to the solenoid part number 971687?
  • How do you test a Falcon 24 or 25 Series EL solenoid?
  • What is needed to keep the EL device retracted all day?
  • How many thread should be showing on the solenoid plunger bushing on EL device to operate correctly?
  • What is a lock function?
  • What is the universal L9000 lock case?
  • PASSAGE FUNCTION
  • Why would the 996L trim not lock or unlock when installed with 98 or 99EO?
  • Does Von Duprin supply the 9875, 9975, 9875-F and 9975-F mortise exit devices with NL-OP trim function?
  • How does the Von Duprin 98/99 rim or vertical rod exit device with lever trim convert from L to L-NL function?
  • Does Von Duprin offer an NL or NL-OP function with the 8827 exit device?
  • How do I change the function of the Von Duprin 7500 mortise lock from Lever ( classroom ) to NL ( night latch )?
  • If using the alarm kit-ALK with the 99 device what power supply is needed?
  • How do you specify an exit alarm ALK with a hard wire to the power supply?
  • Will the PT790 work with the ALK?
  • What is the part number for the Von Duprin maintenance kit?
  • How many P & D (Pierce and Dimple) holes are in a frame?
  • When ordering the mullion stabilizers do you need a set per door or does one set set take care of a pair of doors?
  • Is there a service kit for modular cylinders?
  • What parts are included in the L9000 maintenance kit?
  • How should I clean a biometric hand reader?
  • Are there any instructions for Von Duprin device maintenance?
  • What maintenance is required for an LCN closer?
  • What causes excessive pinhole rust to start showing up on steel frames?
  • What products are available with an antimicrobial finish?
  • Does Von Duprin offer an electric strike in the 6000 Series that works with a deadbolt only?
  • Will the Von Duprin 5654 mullion accept an electric strike?
  • Do we offer a weatherproof electric strike?
  • How hot do the 6000 electric strikes get?
  • Can you use a 5547 with an electric strike?
  • Can the 4854 mullion be ordered as prepped for two 6111 electric strikes?
  • What electric strike will work with mortise lock and aluminum 1 1/2" faced frame?
  • Why won't the 5100 24v strike work on both a RH & LH door?
  • Can the 5100 electric strike be used with a mortise exit device?
  • What is the part number for mounting tabs for electric strikes?
  • How to convert the Von Duprin 6000 series electrical strike from Fail Secure to Fail Safe or Fail Safe to Fail Secure?
  • What is the part number for the 6000 series electric strike 24VDC solenoid?
  • What power supply is required to operate the 6000 series electric strike?
  • What electric strike can be used on a pair of doors with an L9000 lock?
  • What is the operating temperature for 6000 series electric strikes?
  • Can you power a electric strike from the 7900 control boxes?
  • Will the 6210 work with the Best 45H? If not is there another electric strike that is compatible.
  • What is the most common practice for running electric power from a frame to the door and hardware?
  • What are the current and voltage requirements of the 10-042 strike?
  • What is the power output of a 4600 operator?
  • What is the part number for the 6210 spring and lip replacement package?
  • What is the part number for our AL series electric strike?
  • Can the 8200 Series operator power a electric strike?
  • What is the replacement for the Locknetics 9100 series electric strike?
  • Can the 6111 electric strike be used with Falcon 25R?
  • How do you wire an electric strike to a 4600 Series operator?
  • Why is a 5100 electric strike clicking but not locking?
  • Can the electric strike be used in an outdoor application?
  • Can the 6300 electric strike be Fail Safe?
  • Do we have an electric strike for use w/ a mortise lock w/ deadbolt for wood frame?
  • What is the amount of pre-load force allowed for the 6300 electric strike before the strike will no longer release and operate properly.
  • Which electric strike do I use for cylindrical locks used in a single door?
  • Why would an electric strike not stay locked when turned upside down?
  • Can you power an electric strike or maglock from the 9500 Series Senior Swing?
  • ELECTRIC STRIKE RELAY
  • ELECTRIC STRIKE (hardware)
  • ELECTRIC STRIKE
  • What electric strike can be used with the XP98/99 devices?
  • Where can Von Duprin 6300 electric strike installation instructions or templates be found?
  • How can the Von Duprin 4854 mullion be ordered when using the 6300 electric strike?
  • Are the wires on a Von Duprin 6000 series electric strike polarized?
  • What electric strikes can be used with the Von Duprin aluminum mullions?
  • Is a rectifier needed to change AC to DC on Von Duprin 6000 series electric strikes?
  • What is the device backset when using a 1790 with a 6111 strike?
  • Will the 6300 work with the 55 rim?
  • Can the Von Duprin 5100 electric strike be used on a pair of doors?
  • Can the electric strike be used with a vertical rod device on a fire-rated door?
  • Can 24 volts be run to a 12 volt 6000 series electric strike solenoid?
  • Where is the information on the Schlage ES-6400 and Von Duprin 6400 electric strike?
  • Does the Von Duprin 6121 electric strike work with the Von Duprin XP exit device?
  • Are the Von Duprin 6000 series electric strikes rated for continuous duty?
  • What electric strikes are available for Von Duprin rim exit devices?
  • What questions should be asked to determine which Von Duprin 6000 series electric strike I have?
  • Is the Von Duprin 6111 electric strike compatible with Von Duprin XP98/99 rim exit device?
  • Will the Von Duprin 6210 electric strike operate with the MA series locks?
  • What is dual switch monitoring or DS?
  • Will the 6300 electric strike work with the 22 series rim device?
  • Is there an electric strike that will work with the 2670 Guard X?
  • Is there a monitor switch for the 6300 electric strike?
  • What electric strike can be used with the 1790?
  • Is the 8827 available LBR?
  • What is the difference between LR and PL latches on Von Duprin 8827 exit devices?
  • What is the part number for a blade stop shim for a 6111 or 6113 electric strike?
  • How to determine the voltage used by a 6000 series electric strike?
  • What is the offset for the Von Duprin 6211 with the Schlage L 9000 mortise lock?
  • Can 5100 electric strikebe used on fire rated door?
  • Will the 6300 electric strike work with 88-F or the 88 rim panic?
  • Will the 9100 series Benchmark III power an electric strike?
  • What electric strike will work with 1590?
  • Why is the electric E996L-FSE trim used with a Chexit CX99 exit device?
  • Will the door unlock if a Von Duprin CX 98 / 99 Chexit device is deactivated with card reader and has a 996LBE trim?
  • Can the Chexit 98/99 be used with the E996 lever trim?
  • How does the outside trim function on a Chexit Rim or Vertical Rod device?
  • What is the part number for the Trim Device Cable to connect an E996 or RX996 or E7500 to a Chexit module?
  • What is the minimum opening that a Chexit 4' device can be cut down?
  • What non IC cam is offered by Schlage to work in a Falcon MA lock?
  • What mortise cylinder cam do I use on a Falcon MA lock?
  • Is there a cam for a Schlage IC cylinder to operate a Falcon MA lock?
  • What is the difference between the Falcon M and MA series mortise locks?
  • What is the correct cylinder cam # for 718C for a concealed vertical rod device?
  • What cylinder is used in the Falcon 24/25 exit alarm kit?
  • If using the alarm kit-ALK with the 99 device what power supply is needed?
  • What is the part number for the EAK PCB only for Monarch Falcon devices?
  • ALARM KIT
  • What cylinder is used in the Falcon 24/25 exit alarm kit?
  • What is the current draw of a Von Duprin exit alarm kit ALK?
  • Is there an Exit Alarm Retrofit Kit (EAK) for the 19 series?
  • Is the Falcon FSE/FSA 510 L trim available in 12 volts DC?
  • Does the 24 series have electrified trim?
  • Can a 510L be converted from FSA to FSE in the field?
  • Why is my latch not retracting when I depress the push pad on an XP98/99 device?
  • Does the Von Duprin ALK require the RX switch to operate?
  • Why is my Von Duprin QEL light flashing red and green?
  • Why does my Chexit device open without sounding the alarm?
  • The Von Duprin 98 or 99 ALK kit will not sound the horn
  • Why would a 9927 bottom rod drag?
  • Can Von Duprin QEL/EL and CX be in the same device?
  • How does the latch bolt retract on the Von Duprin XP device?