Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ shipping weight Lcn senior swing motor ”

RELATED FAQS

Resolution: How to Order: The Senior Swing header is ordered by the width of the door(s). The measurement from inside jamb to inside jamb of the frame. If the Senior Swing header is ordered the wrong len...:

What is the maximum door weight recommended for LCN closers?

Resolution: The maximum recommended door weight for LCN manual closers is 225 lbs.:

Is the 9500 Series Senior Swing handed?

Resolution: The Senior Swing "control box" is not handed. All Senior Swing motor "gearboxes" are handed, both the 2800 Series concealed and 9500 Series surface mounted operators. The 2800 Series "concealed a...:

Can you use a Senior Swing controller as a replacement for an obsolete Mid Swing controller?

Resolution: The Mid Swing was discontinued Sept. of 2009. The Sr. Swing control box has the power boost feature which the Mid Swing control box did not have. If you replace only the Mid Swing control box...:

When did we start shipping the Senior Swing, Benchmark, and Falcon operators with the ES Filter?

Resolution: On the Benchmark, if there is line noise from a strike then the unit will lose it's hold open time. Adding the ES Filter, which is a diode, will resolve this issue and the unit will hold it's...:

Can you power an electric strike or maglock from the 9500 Series Senior Swing?

Resolution: An electric strike or maglock (24 volt only) can be wired to a Senior Swing 2800/9500 series operator using the P10 Lock Interface cable.For Current Sr Swing control boxes with ID# 72940 on th...:

How do you install the LCN 9530 Senior Swing (STD) pull arm?

Resolution: When installing the arm; the gearbox shaft and door must be at the (+90°) full open position. The following step are used to install the Senior Swing (STD) pull arm. Install...:

How do you install the LCN 9540 Senior Swing (REG) push arm?

Resolution: When installing the arm; the gearbox shaft and door must be at the (+90°) full open position. The following step are used to install the Sr. Swing (REG) push arm. Install t...: