Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ safety data steelcraft ”

RELATED FAQS

Resolution: Security anchors are used in DW/K frames located directly above or below strike preparation on door side of frame. Because there are only two points of anchoring, the compression anchor near the ...:

What is the part number for the wire harness or cable for an LCN DMSS, 8310-804-1 or 8310-804-2?

Resolution: The 8310-804-1 or 8310-804-2 DMSS Harness cable is part number: 8310-847.Cable is also listed in the instruction manual as: 761467-00.:

Can a magnet, or sentronic device, be released and close the door from a button at a desk?

Resolution: If a door is being held open by the LCN SEM 7800/1900 magnet or any ME/SE Series Sentronic LCN closer, you can remotely release that door to close by ordering the following parts and wiri...:

How is the 8310-877 wired to the 4600 (4630 4640) operator?

Resolution: The 8310-877 comes with a 6 wire cable. You have to cut the connectors off both ends and hardwire it to the 4600 operator as follows: The 6 wire cable connections to the 7 pin connector in the 8310...:

What is the Multi Point LM9300 Series?

Resolution: MultiPoint locks are three-point locking systems that secure the door at three points – top, bottom, and traditional center latch location. Operating just like traditional locks, MultiPoint locks...:

Is a Steelcraft Tech Data Manual available?

Resolution: A current PDF copy of the Steelcraft Tech Data Manual is available on the Steelcraft website and can be downloaded here.To order a printed copy of the Steelcraft Tech Data Manua...:

What is clear opening width?

Resolution: Clear Opening Width for swinging doors is measured (with the door open 90 degree) from the face of door to stop soffit on strike jamb. &nbs...:

What are the different door cores available?

Resolution: The five most common cores are honeycomb, polystyrene, polyurethane, steel stiffened, and temperature rise. Honeycomb core doors are used for interior and exterior openings where high thermal...:

What is an astragal?

Resolution: An Astragal is an applied molding attached most commonly to the meeting edge of doors to: Protection against weather conditions Minimize the passage of light between the doors Retard the passa...:

Are glass lights available in the H-Series door?

Resolution: Steelcraft offers all the standard lights as well as special size glass lights in the H-series door. Effective April 1, 2012, (Bulletin # B-100.12) the default for Dezigner Trim in H-Series D...: