Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ double egress undercut ”

Resolution: The 4040SE uses the regular arm for any Push Side mounting (minimum 28" door width). ST-2788 (a special arm and track) can be used to mount a 4040SE on the Push Side of a smaller (narrow) doo...:

What is an astragal?

Resolution: An Astragal is an applied molding attached most commonly to the meeting edge of doors to: Protection against weather conditions Minimize the passage of light between the doors Retard the passa...:

Are astragals required on fire doors?

Resolution: Astragals are required on: 3 hour fire rated pairs: Double doors - swinging in the same direction Double Egress - swinging in opposite directions Fire rated Dutch Doors Fire rated 1 3/4" t...:

What is the definition of double egress?

Resolution: Double Egress Opening: A pair of swinging doors, each leaf which swings in the opposite direction of the other. DOORS: A pair of doors swinging in opposite directions without a vertical mullion....:

What is the maximum size of a UL fire rated three (3) sided frame?

Resolution: Fire Rated three (3) frames are available in the following maximum door opening sizes: F and FN-Series frame:4' 0" X 10' 0" single door opening8' 0" X 10' 0” double door openingMU-Series frame...:

What astragals are available?

Resolution: Types of astragal offered from Steelcraft are as follows: "Z" Astragal - For information on "Z" astragal types and attachment refer to the TD Manual page 3.3.17. Most commonly used on double ...:

Can wood doors be used with with double egress frames?

Resolution: Yes, wood doors can be used and installed in most hollow metal frame applications including FE-Series and DE-Series Double Egress frames. Caution - For fire rated applications the wood door manufa...:

Can fire rated double egress frames have side lights or transoms?

Resolution: No. Fire rated double egress frames must be a stand alone 3 sided frame assembly. If transom lights and/or sidelights are required, they must be built and installed as separate Fire Window assemb...:

DOUBLE EGRESS ARM

Resolution: DE, Track Style Arm:

UNDERCUT

Resolution: Floor Clearance, Clearance:

What is the maximum door undercut for fire rated vertical rod exit devices?

Resolution: For devices with bottom latches and strikes, the maximum undercut is 1/4" to ensure latching in the case of a fire. For devices approved without bottom latches and strikes, using the AFL (aux...:

Will a Von Duprin Chexit device automatically rearm itself after a fire alarm clears?

Resolution: The Von Duprin Chexit device will not automatically rearm itself after a fire alarm clears. After a Fire Alarm has triggered the Von Duprin Chexit device, the device must be manually reset&nb...:

Is there a mullion for use in double egress applications?

Resolution: There is no mullion for double egress openings. Mullions only applies to the doors that open in the same direction.:

Can a Senior Swing 2850 or 2860 be used on a Double Egress (DE) door?

Resolution: The overhead concealed operators (2850/2860) will not work on a Double Egress frame because the doors are not in the same plane. You will have to use the surface mount (9553 / 9563) on Double Egres...:

What is the difference between the FE and DE-Series frames

Resolution: A Double Egress frame is a double door frame prepared to receive two single-acting doors swinging in opposite directions (both doors are) the same hand. These openings are installed in cross corrid...:

What is the door undercut for a 25-C device?

Resolution: The bottom rod of the device will accommodate a 1/4" to 3/4" door undercut per 2130 template .:

DOUBLE EGRESS MULLION

Resolution: Contra-swing mullion; Opposite Swing Mullion:

DOUBLE EGRESS FRAME

Resolution: FE-Series, DE-Series; two way corridor openings:

DOUBLE EGRESS DOORS

Resolution: ; two way corridor openings:

FRAME

Resolution: DE-Series, DW-Series, FN-Series, F-Series, FE-Series, K-Series, MU-Series, FP-Series, FR (Double Egress Frame, Drywall Frame, Drywall Slip on Frame, Multi-Use Frame, Tornado Resistant):

What is the purpose for using a 12 gage head reinforcement?

Resolution: Purpose: When there is concern for the weight of overhead wall construction, or, when multiple surface applied hardware components are being used. This continuous channel has the ability to spre...:

L9462

Resolution: Double cylinder mortise lock - Deadbolt is operated by key on either side. - Caution: Double cylinder locks on residences–or on any door in any structure which are used for egress–are a life safety...:

FE-SERIES

Resolution: FE16, FE14, FE Series; Double Egress, Cross Corridor:

Can DW/K frame series be used in high traffic areas?

Resolution: DW/K-Series frames (Drywall Slip-On) are not recommended for installation in high traffic areas. DW/K-Series frames are installed in interior stud walls after the wall board is installed and ...:

Can a 4600 operator be mounted with pivots?

Resolution: On a single door take the mounting dimensions from centerline of pivots (offset or center) On a pair of doors, depending on the door width and pivots being used, the operators can bu...:

What is a mechanical Lock?

Resolution: A lock is any device which prevents access or use by requiring special knowledge or equipment. Mechanical locks are mechanical devices which secure an opening by keeping a door closed until a rel...:

L9095EL/EU

Resolution: Electrically locking and unlocking both levers (inside and outside cylinders) - Both levers continuously locked (EL) or unlocked (EU) by 12 or 24V DC. EL is fail safe (power failure allows outside ...:

L9495EL/EU

Resolution: Electrically locking and unlocking both levers (inside and outside cylinder with deadbolt) - Both knobs/levers continuously locked (EL) or unlocked (EU) by 12 or 24V DC. EL is fail safe (power fail...:

L9493EL/EU

Resolution: Electrically locking and unlocking both levers (outside cylinder, inside thumbturn with deadbolt) - Both knobs/levers continuously locked (EL) or unlocked (EU) by 12 or 24V DC. EL is fail safe (pow...:

HINGE SIDE REVEAL

Resolution: Track Style, Double Egress Mount:

CONTRA-SWING FRAME

Resolution: Double Egress with a mullion; Opposite Swing Frame:

LM9291EL/EU

Resolution: Electrified both levers lock, two-point latch - Electrically locking/unlocking both levers. Latchbolt(s) retracted by outside or inside lever when unlocked. Requires doors specifically designed for...:

LM9295EL/EU

Resolution: Electrified both levers lock two-point latch (inside and outside cylinder) - Electrically locking/unlocking both levers. Latchbolt(s) retracted by outside key and lever, by inside key and lever, or...:

LM9293EL/EU

Resolution: Electrified both levers lock two-point latch (outside cylinder) - Electrically locking/unlocking both levers. Latchbolt(s) retracted by outside key and lever, by electrically unlocking door, and by...:

PARALLEL BEVEL EDGE

Resolution: Double Egress Doors:

FRAME PROFILE

Resolution: Cased Open, Single Rabbeted, Double Rabbet, Unequal Rabbet, Equal Rabbet, Double Egress:

Does a SEH require a door closer?

Resolution: The SEH is an "electronic holder" (ONLY) that is used to hold open a Fire Rated opening. It requires a door closer to be mounted on the opposite side. It is normally used on an existing opening wit...:

LM9271

Resolution: Classroom security lock* two-point latch - Latchbolt(s) retracted by lever from either side unless locked by key from either side. When outside is locked, latchbolt(s) retracted by key and lever ou...:

Can DE-Series frames be prepared for pocket pivot hinges?

Resolution: Pocket pivot hinges are mainly used in cross corridor applications where clear opening width is a factor. For frames, pocket pivot hinges are a special hinge options which must be spe...:

What are the minimum header lengths for a Senior Swing?

Resolution: The minimum header lengths for a Senior Swing with standard Spindle centers are:Concealed 2810 Series:2811 single door (offset pivot or butt hinge) -- 33".2811 single door with stop (cent...:

Can a 4040XPT DE be used with a 4" reveal on the pull side?

Resolution: The LCN 4040XPT with a reveal deeper than 1/8" on the pull side of the opening requires a Double Egress (DE) arm.DE arms are handed arms and cannot have handing changed in field.ST3073 Standard 404...:

DE-SERIES

Resolution: DE16, DE14, DE Series; Double Egress, Cross Corridor:

L462

Resolution: Double cylinder lock - Deadbolt is operated by key on either side. - Caution: Double cylinder locks on residences–or on any door in any structure which are used for egress–are a life safety hazard ...:

L9466

Resolution: Storeroom/utility room lock - Latchbolt is operated by knob/lever from either side. Deadbolt is operated by key from either side. - Caution: Double cylinder locks on residences–or on any door in an...:

L9482

Resolution: Institution lock with deadbolt - Latchbolt is operated by key from either side. Knob/lever on both sides is always fixed. Deadbolt is operated by key on either side. Auxiliary latch deadlocks latch...:

Resolution: Double Egress Arm, Double Egress:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ double egress undercut ”

RELATED FAQS