Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

What is the standard door gap, between the top of a door and the frame?

Resolution: 1/8":

What is the difference between the 026XY and the 027XY hinges.

Resolution: One leaf is bigger so that the 026XY would be used when smoke seal or gasketing is used:

What is the function description for the Falcon H2171?

Resolution: H2171Latchbolt retracted by lever from either side. Deadbolt thrown or retracted by turn inside or retracted by emergency key outside. Rotating turn from inside extends deadbolt and changes v...:

Are the Everest B and Everest R keyways restricted?

Resolution: All product with Everest B and Everest 29 R keyways are restricted - this includes key blanks, cut keys, combinated SFIC cores, uncombinated SFIC cores*, and all Everest SL cylinders both conventio...:

What is the measurement a LM9200 is mounted from a finished floor?

Resolution: The LM9200 height from the finished floor should not exceed more then 3" (higher or lower) than the recommended 39-5/8". This is true whether the lock is supplied with the bottom latch or less bott...:

Is the small format IC tail piece for ND the same tail piece for CO?

Resolution: The ND and CO small format IC tail pieces are different lengths. The ND tail piece is 1.83" long and the CO tail piece is 1.57" long. :

When did Schlage FSIC Construction cores change from Black to Orange?

Resolution: The FSIC Schlage construction cores changed from black to orange in September 2019. :

Can L9000 door prep be retrofitted to accept an L400?

Resolution: Schlage does not recommend retrofitting L9000 door prep for L400 locks.Instead, Schlage recommends using the L9000 equivalents of the L400 to fit existing prep, e.g. instead of L460 use L9460. ...:

What does LD mean?

Resolution: Less dogging:

What thickness of door will the tailpiece on back of 912L and 712L support?

Resolution: 1 3/4" to 2 1/4":