Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

On a CO-100-CY, will the 14-051 2-3/8" Backset, Dead latch and the backset extension link be enough to make the 5” backset?

Resolution: On a CO-100-CY, will the 14-051 2-3/8" Backset, Dead latch and the backset extension link be enough to make the 5” backset? No, because it is an extension link, it needs to start with th...:

What is the minimum byte credentials need to be to use No tour?

Resolution: What is the minimum byte credentials need to be to use No-tour? No-tour credentials needs to be at least 1k bytes. Anything under, like the 2.5k bit cards will not work. Also note the MT20W e...:

When AD300 is connected to the PIB300, will the privacy function work?

Resolution: When AD300 is connected to the PIB300, will the privacy function work? No, when the AD300 is going through the PIB300, the privacy function will NOT work.:

What is positive latching?

Resolution: A spring loaded throw on the edge of the door that engages into a strike plate on the door frame.Schlage and Falcon locks with a latch meet this requirement. :

When the Benchmark Operator is in the Hold open position, what is the holding voltage on the motor?

Resolution: Approximately 5 volts.:

What is the P valve on the Falcon SC70 or SC70A Closer used for?

Resolution: This P valve or PA selector valve on the Falcon SC70/SC70A closer is a "Backcheck selector valve" that needs to be turned in on "Parallel Arm" mount applications ONLY. If this valve is not tu...:

What is the P valve on the LCN 4050A Closer used for?

Resolution: This P valve or PA selector valve on the LCN 4050A closer is a "Backcheck selector valve" that needs to be turned in on "Parallel Arm" mount applications ONLY. If this valve is not turned in ...:

Will LCN sell internal components of a door closer cylinder?

Resolution: No.:

When were the benchmark (9130/9140/9150) adapter harnesses -3428-1, -3598, -3430 cables made obsolete?

Resolution: April 4th of 2008.:

Are the CL100 or CL200 cabinet locks available for a 1-3/8" thick door?

Resolution: The CL100 and CL200 can be ordered for a 1-1/8" or 1-3/8" thick door. If no dimension is specified, 1-1/8" is the default.: