Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Is the 1690 exit device compatible with a push button lever lock?

Resolution: No. The 1690 device requires 180 degrees rotation to retract the latch. This is too great to work with push button lever locks.:

When was the Falcon 20 exit device launched?

Resolution: Falcon 20 was launched in April of 2018.The Falcon 20 device is a price-sensitive Grade 1 device for use with 161 KIL trim prep.:

How can an old 4610 be wired up sequentially to a new 4630?

Resolution: You can accomplish this by: using a LCN 8310-865 receiver on each unit and going to wireless actuators. using a Sequential relay/module. ...:

Can a diode be used with the ND electrified lock?

Resolution: As long as the voltage delivered to the wires of the electrified ND lock is between 10.2VDC and 26.4VDC, a diode, or string of diodes, in series with the positive output of the power supply should ...:

Is there a shim to adapt from the old EPT to the new EPT?

Resolution: The older EPT (approximately before 1997) were "wider" than the new ones . We can supply two neoprene strips to take up this gap.The part # for the neoprene is 900978....:

Which Allegion Devices Have The CE Mark, or CE Certification

Resolution: CE Certification information can be found on the Allegion UK website at https://www.allegion.co.uk/en/downloads/ce-certs.htmlShould this link change over time and not provide the c...:

Is the 2090 exit device different depending on outside trim function (EO , NL, HB)?

Resolution: The 2090 exit device has a single chassis design. If you have an EO application and want to change to NL (nightlatch) or HB (hold back) function, simply add a rim cylinder (and pull, if desir...:

Is lead lining available for the HL6 latches?

Resolution: Lead lining is if offered as a separate component (to be installed in the field). The parts are offered for various backsets, see pricebook.:

What is the red marking on the end plug of my LCN 4600, 4800, or 2600 operator?

Resolution: This is just a color coding we use to identify the housing for the standard 4631, 2610, 4811, and 4840. - because these all get the spacer inside the housing to restrict the opening distance.For an...:

What is the part number for a Schlage FSIC hotel cylinder?

Resolution: The Schlage L9486 and L9485 use the following hotel FSIC parts:30-120 with logo 30-121 less logo :