Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

What is the part number for the Schlage L400 series mortise lock dust box?

Resolution: There are two part numbers for the Schlage L400 series dust box:K510-053 used with the 10-079 strikeK510-066 used with the 10-079 strike:

What is the part number for the STD mount in BLK finish

Resolution: The 3/8" HD Standard mount 1-1/2" – 1-7/8" door in BLK finish is PULLPART.1230.:

Can a 119" continuous hinge work on a taller door?

Resolution: This is not recommended.Generally the continuous hinge should be approximatly 1" shorter than the height of the door.:

Is the mid mounting bracket (when ordered as standard) on a latter pull centered between the other two mounting posts

Resolution: When ordered as standard the mid mounting bracket will be centered between the two other mounting posts.If a different location is desired, please provide a drawing with the locations of all mounti...:

What replaced the 40-126 key punch?

Resolution: The 40-126 was the key punch for cutting Schlage Obverse keyways. The 40-075 replaced the 40-126.:

Can a L9000 sectional indicator cove the prep from the 09-611 Chevron indicator?

Resolution: From the centerline of the sectional indicator cylinder to the bottom of the indicator measures 2.356" From the centerline of the Chevron indicator cylinder to the bottom of the indicator meas...:

What is the Minimal Stile requirements for Falcon Locksets?

Resolution: :

Can SOSS hinges be used on a beveled edge door?

Resolution: SOSS hinge can be used on both, beveled edge, or square edge doors. Note: It is important not to exceed the E-dimension/set back of the hinge, the type of edge on the door isn't as important.:

What is the 1388 Hex wrench for Falcon T series locks?

Resolution: The Falcon T lock ships with a plastic 1-7/16" hex wrench (internal part number 030701-000). See picture. It is used to tighten and/or remove the flange nut on the Falcon T series chass...:

What lever styles are available for the Falcon W18?

Resolution: The W18 is only available in Dane and Quantum lever styles. :