Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Will a Glynn Johnson 104S work with a Falcon SC71A pull side mount closer?

Resolution: You will need to use the SC70A-18 drop plate and use the bottom middle holes for mounting to avoid conflict with the GJ100 series in top of the door.Note: the lower screws are another ¾” down...:

Are the senior swing angle brackets handed?

Resolution: The senior swing angle brackets (334-1) are handed. When you order the 9540-334-1 angle brackets, you will receive one A and one B bracket with the surface mounted senior swing:

How many cartons is the 4642 shipped in?

Resolution: The 4631/4642 ships in one carton. Inside of that carton will be 3 separate boxes containing. Cylinder and Arm kit Mounting plate and cover kit Controll...:

What is the length of the standard 2010 arm?

Resolution: The total length of the 2010-3077T standard arm is approximately 14.”This arm is 13" from Centerline to Centerline.:

What is the length of the standard 2030 arm?

Resolution: The total length of the 2030-3077T standard arm is approximately 14”This arm is 13" from Centerline to Centerline:

Is there a SOSS closing hinge that will work with the 518 series?

Resolution: There is not a invisible closer hinge (IC) that will work with the 518 series of invisible hinges.:

Can you mount a 4630 on a 32’ door?

Resolution: You can use ST-3070 to mount a 4631 on a 32” door. This will give the unit a 100 degree power opening and the closer must be able to hang over the frame face at the hinge edge of the door. &n...:

Can I use a on/off switch with the 4040SE closer?

Resolution: You would wire the NC/COM contact of the on/off switch you are using, to one leg of the incoming power - if the switch opens, power is broken and the solenoid will release the hold open.:

Can a 4040XP pull side mount closer clear a 6" side wall?

Resolution: For a 4040XP to be mounted pull side and clear a 6” side wall you will need to use ST-3146. This application uses a special arm as well as special templating. Please Note: This application wi...:

What is the part number for the 4040XPT shaft spacer?

Resolution: 4040XPT-61 is the part number for just the shaft spacer. This part can be ordered separately. :