Set the dip switches 1 to the "OFF" (pulse) position.
Set the dip switches 2 to the "OFF" (0.5s) position.
Momentarily press the " No Delay" or "Delay" button (depending on required operation). The red LED light will come on solid for about 10 seconds.
While the red LED is on, press actuator button (transmitter button) 2 to 3 times until blue light comes on.
Actuator button (transmitter button) is now programmed to the receiver.
Repeat steps 1-4 for each actuator button to be programmed.*(see note)
To "Reset" or "Clear Program" of the 8310-865 receiver:
Press and hold both the "No delay" and "Delay" buttons until the blue light comes on. This can take up to 10 seconds.
DISCLAIMER:
INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES
OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO
YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.
YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE
USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS
MADE AVAILABLE THROUGH THIS SITE.