programming button for SNAP

RELATED FAQS

Question
Answer
B600-092 is the inside snap-on faceplate for all non-IC double cylinder B562 and B662/762/862 deadbolts.
To adjust the hold open time on a 4600 (4630/4640) operator: Press the "MODE" button on the control box 1 time to get into programming mode. The "YELLOW" mode indicator LED next to "HOLD OPEN TI...
All Senior Swing models are heavy duty operators and have the Push-N-Go (PNG) feature.  This feature is a programmable function in the control module.  The PNG settings are: Off, On, or FD (fixed)...
Out of the Box, or after a Factory Default Reset, all AD locks can be used in a "Construction Mode".    At launch ...   The AD-Series locks would accept the first card credentia...
Update your device firmware to the latest version to fix this early design / feature update
The circuit board in a motor driven Chexit delayed egress exit device and DE5300 delayed egress controller manufactured after 8/24/2015 has a button labeled RESET.  This is located between t...
A replacement BNC cable has been found through the manufacturer, E-Z Hook.  This company makes electronic testing equipment, and this cable is believed to be a good working replacement fo...
This product is obsolete and is no longer available from Schlage Electronics.
A user can import the user names and associated I-Buttons into SMS express by using the PEOPLE.SPP file from the SNAP folder and the USER IMPORT from TEXT FILE feature. 1.    ...
Yes, although using the SNAP programmer is not recommended, because it is more difficult to program through the computer. In addition, Schlage no longer sells the SNAP programmer. The be...
To program the 8310-865 receiver: Set the dip switches 1 to the "OFF" (pulse) position. Set the dip switches 2 to the "OFF" (0.5s) position. Momentarily press the " No Delay" or "Delay" ...
DATE and TIME Facts – KC2-Deadbolt, BE-367, PED-500, PED-1000: • The deadbolt clock circuitry directly uses the battery as its power source. If the deadbolt battery is removed, the clock can keep...
Toggle codes will change the main relay state indefinitely.  To return to the initial state a toggle code must be entered again..   To program a Toggle Code into...
Power down the keypad then remove both JP1 & JP2 internal jumpers. Power up the keypad and wait a few seconds, the keypad will beep. Power down again, then reinstall the jumpers. Power back on....
No.  As of June 27th, 2018--- the cover screw is now standard in the screw packs for the 4040XP, 4040XPT, 4000T, and 4040SE so ST-3596 is no longer needed.