Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ why do you preload LCN closer ”

Resolution: 4040XP Series (4040 DEL) is a universal closer. *(see note) Non Handed closer. Can be mounted on a RH or LH door. 4041XP - Adjustable size 1 to 6. Can mount push side or pull side of the doo...:

What are the Rod and Shoe lengths for 4000 and 1000 series closers?

Resolution: STANDARD ROD AND SHOE: 4020, 4031, 1460, 1260, 4640, 4820 is: 8 3/8” (obsolete product 1520, 1370, 1070 had same length)LONG ROD AND SHOE: 4020, 4031, 1460, 1260, 4640, 4820 is: 12 3/8” (obso...:

What is the delay time adjustment on a Delayed Action closers?

Resolution: Regular LCN closers have "3" regulating valves for General Speed, Latch Speed, and Backcheck. If the LCN closer has "4" regulating valves, then the closer has the Delayed Action feature. De...:

When did they start putting the green dial's on the 4041 closers?

Resolution: LCN started putting on the green dials for the spring adjustment on the 4041's in 2001.:

Are there parts available for the obsolete 330 series door closer?

Resolution: The 330 closer and parts were discontinued in early 2009. LCN does not have any parts available for the 330 series closer. The LCN 3030 Series would be the comparable closer replacement to the...:

What arm can I use for the old LCN 4030/4130 closer?

Resolution: The old 4030/4130 closers and arms are obsolete, there is nothing to replace them. No arm from other closers will fit There is no closer that can replace the old 4030 series closer with the exa...:

Can I mount an LCN Cush closer with an GJ overhead stop?

Resolution: It would be unnecessary to use the CNS/Cush arm and the Glynn Johnson overhead devices in the same application, both mechanisms stop the door.:

Does the old style 4030 have the same templating as the new style 4031?

Resolution: The old 4030 series was: Handed Mounted regular arm hinge side. Had sized springs, were not adjustable. The 4033 is an obsolete closer. If required, handing can be verified by looking at ...:

What is a 4430 / 4330?

Resolution: The 4330 / 4430 is an obsolete ME closer replaced by the 4310ME or 4410ME Series.:

What size Allen wrench is used for Closer adjustment?

Resolution: LCN does not supply Allen wrenches. The size allen wrenches that LCN uses, are standard sizes that every installer will have in their tool kit. 3/32" Allen wrench for adjusting&...:

In what direction should the hold open nut be pointing for a 4041 H closer, up or down?

Resolution: Make sure that the hold open nut is not on upside down. The orientation of the hold open nut depends on the mounting. On a Top Jamb "Push Side" mount, the hold open nut would poi...:

FULL COMPLIMENT BEARINGS

Resolution: Low friction, high load needle bearings found in all LCN closers:

Can LCN closers be installed outside in the elements?

Resolution: The LCN closers are not designed nor intended to be exterior mounted in the elements. :

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ why do you preload LCN closer ”

RELATED FAQS